This time I'll make a 3D printed rc boat, the design can be downloaded from Thingiverse from its creator/designer called Wersy on Thingiverse. The rest of the steps are going to be described in this ...

3d printing is so much fun, I had the best time with this crazy project!! How do you think it would hold in the ocean? I wouldn't use it to cross too big of a body of water 🤣 ...

With all its fittings and a sleek, shiny coat of paint in a snapper rocks blue metallic colour, the boat was officially launched and displayed at the 2020 Genoa Boat Show to welcome its audience to ...

This miniature boat was inspired by Minecraft and made with a 3D printer. It has its very own 3D-printed skipper who can paddle and even fish from it. If you’re into the Minecraft video game ...

This boat is so small, it could float down the interior of a human hair. The 3D-printed boat is part of an exploration of microswimmers, microscopic organisms or objects that can move through liquids.

That’s a bold statement, but as the term applies to anyone who has built a boat, we’d argue that it encompasses anyone who’s run off a Benchy, the popular 3D printer test model.

Physicists at Leiden University in the Netherlands have 3D printed what could be the world’s smallest boat, a test object known as Benchy (via Gizmodo). At 30 microns long, it’s a third ...

This is a 10-foot long (3 meters) flat-bottomed boat with a very shallow draft that can be used for leisure rides on calm lakes and in shallow waters. The hull and cabin weigh 800 lbs (363 kg ...

The world’s largest 3D printed object is this boat, produced at the University of Maine. Ron Lisnet/University of Maine It’s reported 5,000-pound weight and 40,000 dollar cost are both high, compared ...

Before printing anything, you need a 3D model of the object you’re trying to create. The computer model is then "sliced," essentially dividing it into hundreds (or potentially thousands) of layers.

You’ll also need to use supports, so expect to spend a fair bit of time cleaning it up post-print. The rest of the model can be printed at 0.3mm, which is going to save a lot of time on the hull.