So one reader made knife containers out of 2 pvc pipes and caps. He glued the cap on one end and marked the unglued cap with an 'X.' That way he always knows which end to open. We think this is one of ...

With the PVC pipe upright, tap the end cap on with a dead-blow hammer or mallet. Twist the end cap slightly to evenly distribute the cement, then finish tapping the cap until it is firmly seated.

Grease: To build the gun’s body, glue the nozzle (the 2-inch cap with the small hole(s) you drilled) onto the 2-inch-by-24-inch PVC pipe [1]. Let the glue dry for 15 minutes, then dab some ...

If you’ve used PVC as a building material in your projects you may have run into trouble finding a way to make three pipes joint at right angles to each other (like the corner of a box outlin… ...

Other than the PVC pipe, caps and ends, you only need a drill to create the holes. If you have a clunky shower head, this is a great DIY solution to a usually expensive replacement.

The boots dry on perforated PVC pipes that waft warm, gentle air supplied by a light bulb and a computer fan. Build the box out of ½-inch-thick plywood, 1-inch deck screws, two light switches, a ...