Technologies GmbH & Co KG
Closed Loop Precise Hall Current Sensor CYHCS-SH
This Hall Effect current sensor is based on closed loop compensating principle and can be used for measurement of DC and AC current, pulse currents etc. The output of the transducer reflects the real wave of the current carrying conductor.
Product Characteristics
Excellent accuracy Very good linearity Accuracy independent on the position of premiary cable Lager measuring range
Applications
Photovoltaic equipment General Purpose Inverters AC/DC Variable Speed Drivers Battery Supplied Applications Uninterruptible Power Supplies Switched Mode Power Supplies
ELECTRICAL DATA
Part number Nominal input current Measuring range Turns ratio Measuring resistance Supply voltage Nominal output current Accuracy at +25C Current consumption Galvanic isolation Secondary internal resistance CYHCS-SH1000A 10A ~1000A 0-10A ~ 0-3000A 1:5000 with Vc=15V, @1000Amax, 0-30, @1500Amax, 0-5, with Vc=24V, @1000Amax, 0-68, @3000Amax, 0-3, 15VDC ~ 24VDC 2mA 0.2% ~ 200mA 0.2% 0.2%FS 28mA + Output current at Vc=15V 50Hz, 1min, 6KV Ta=25C, 32
ACCURACY DYNAMIC PERFORMANCE
Zero offset current Ta=25C Magnetic Offset current IP0 Thermal drift of offset current Response time Linearity Accuracy Bandwidth(-3dB) di/dt < 0.2mA < 0.2mA IP=0, Ta=-40C ~ +85C, 0.5mA <1s 0.1%FS 0.2% for rated current 10A ~1000A DC150kHz >100A/s
GENERAL DATA
Operating temperature Storage temperature -40C ~ +85C -40C ~ +125C
Markt Schwabener Str. 8 D-85464 Finsing Germany
Tel.: +49 (0)8121 2574100 Fax: +49 (0)8121 2574101 Email: info@cy-sensors.com http://www.cy-sensors.com
Technologies GmbH & Co KG
Dimensions (mm)
+ M
+ M-
+M-
+ CYHCS-SH M -
+ IS RM
0V -
+ M:
+15~+24VDC -15~ -24VDC Output current
Operating instructions
1. Connect the terminals of power source, outputs respectively and correctly, never make wrong connection for DC current. 2. Temperature of the primary conductor should not exceed 100 C. 3. Dynamic performances (di/dt and the response time) are the best with a single bar completely filling the primary hole. 4. In order to achieve the best magnetic coupling, the primary windings have to be wound over the top edge of the device.
Markt Schwabener Str. 8 D-85464 Finsing Germany
Tel.: +49 (0)8121 2574100 Fax: +49 (0)8121 2574101 Email: info@cy-sensors.com http://www.cy-sensors.com