Scribd
Upload
221 views6 pages

Ultrasonic Gauging Guide

This document is from Apt Inspection Technologies and describes standards for ultrasonic thickness gauging. It is the fourth revision of document AIT/UTG/00. The revision updates the document for cladding measurement thickness. The document contains sections on scope, surface preparation, personnel qualifications, equipment, calibration, procedures, recalibration, marking, evaluation, certification, and cleaning.

Uploaded by

Arun
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
221 views6 pages

Ultrasonic Gauging Guide

This document is from Apt Inspection Technologies and describes standards for ultrasonic thickness gauging. It is the fourth revision of document AIT/UTG/00. The revision updates the document for cladding measurement thickness. The document contains sections on scope, surface preparation, personnel qualifications, equipment, calibration, procedures, recalibration, marking, evaluation, certification, and cleaning.

Uploaded by

Arun
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 6

Apt Inspection Technologies

Title Document No. Rev. Page

AIT/UTG/00 04 1
ULTRASONIC THICKNESS GAUGING
Volume No. Product/Structure

Doc Type Derived From Rev.

Job No. Project Client

STANDARD

Rev. KIND OF REVISION

04 General revision. Updated for the cladding measurement thickness.

Engineer Engineer Quality NDT Lev III

Bhanu Kiran Balakrishna L.V.Rama Rao 25/10/2012

Prepared Checked Checked Checked Checked Approved Date

Confidential information, property of Apt Inspection Technologies - Not to be used for any purpose other than that for which it is supplied
Apt Inspection Technologies

Project Doc no. Rev. Page

STANDARD AIT/UTG/00 04 2

INDEX

1. SCOPE
2. SURFACE PREPARATION
3. PERSONAL QUALIFICATION
4. EQUIPMENT AND COUPLANT
5. CALIBRATION BLOCK FOR CARBON LOW ALLOY OR ALLOY STEEL TUBE
MATERIAL
6. CALIBRATION OF THE EQUIPMENT
7. PROCEDURE
8. RECALIBRATION
9. MARKING
10. EVALUATION
11. CERTIFICATION
12. CLEANING
Apt Inspection Technologies

Project Doc no. Rev. Page

STANDARD AIT/UTG/00 04 3
Apt Inspection Technologies

Project Doc no. Rev. Page

STANDARD AIT/ UTG /00 04 4


Apt Inspection Technologies

Project Doc no. Rev. Page

STANDARD AIT/ UTG /00 04 5


Apt Inspection Technologies

Project Doc no. Rev. Page

STANDARD AIT/UTG /00 04 6

You might also like