100% found this document useful (7 votes)
10K views1 page

Volvo EC210B LC Fault Guide

This document provides diagnostic information for a Volvo engine that has detected a fault with the water in fuel indicator. It describes three fault modes that can occur: FMI 0 detects low voltage indicating water in the fuel, FMI 3 detects high voltage from a short circuit, and FMI 4 detects low voltage from a short circuit. For each fault mode, the detection conditions, symptoms, possible causes, and recommended actions are summarized to aid in troubleshooting the issue.

Uploaded by

Masfakih Am
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
100% found this document useful (7 votes)
10K views1 page

Volvo EC210B LC Fault Guide

This document provides diagnostic information for a Volvo engine that has detected a fault with the water in fuel indicator. It describes three fault modes that can occur: FMI 0 detects low voltage indicating water in the fuel, FMI 3 detects high voltage from a short circuit, and FMI 4 detects low voltage from a short circuit. For each fault mode, the detection conditions, symptoms, possible causes, and recommended actions are summarized to aid in troubleshooting the issue.

Uploaded by

Masfakih Am
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Volvo Guided Diagnostics

Date: Information Type:


4/4/2014 0 Diagnostics Fault Codes 128: Engine ECU 97: Water in fuel indicator
Profile:
EXC, EC210B LC (Volvo) [ID] EXC, EC210B LC (Volvo) [ID] EXC, EC210B LC (Volvo) [ID] EXC, EC210B LC (Volvo) [ID] EXC,
EC210B LC (Volvo) [ID]

MID128 Engine ECU;PID97 Water in fuel indicator(128 PID97)


128 PID97

Reference

Fault mode diagnosis

Fault mode Detection conditions:The engine control unit (E-ECU) registers: that the voltage is below
FMI 0 0.75xUbat (EB8)
Symptom: Possible causes:

¡ Red central warning ¡ Water in fuel


¡ Buzzer sounds one time ¡ Defective sensor
¡ Error message screen

Action Drain water in fuel See operator's manual.

Fault mode Detection conditions:The engine control unit (E-ECU) registers: that the voltage is above
FMI 3 0.91xUbat (EB8)
Symptom: Possible causes:

¡ Red central warning ¡ Signal line short-circuited to higher


¡ Buzzer sounds one time voltage
¡ Error message screen ¡ Defective sensor

Action 128 PID97

Fault mode Detection conditions:The engine control unit (E-ECU) registers: that the voltage is below
FMI 4 0.05xUbat (EB8)
Symptom: Possible causes:

¡ Red central warning ¡ Signal line short circuited to lower


¡ Buzzer sounds one time voltage
¡ Error message screen ¡ Defective sensor

Action 128 PID97

Guided Diagnostics

You might also like