Scribd
Upload
134 views9 pages

Work Is in Place and Work Site

This document outlines the procedures and safety measures for a job involving crane operation. It identifies potential hazards at each stage of the job and the corresponding safe practices to address them. The stages include pre-job planning, setting up the crane, lifting loads, and cleaning up after completion. Hazards include heat stress, simultaneous operations, dropped loads, and injuries from tools or lifted materials. The safe practices emphasize having the proper tools, permits and inspections, conducting meetings, maintaining distances, and stopping work if unsafe conditions arise.

Uploaded by

Mark Roger Huberit II
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
134 views9 pages

Work Is in Place and Work Site

This document outlines the procedures and safety measures for a job involving crane operation. It identifies potential hazards at each stage of the job and the corresponding safe practices to address them. The stages include pre-job planning, setting up the crane, lifting loads, and cleaning up after completion. Hazards include heat stress, simultaneous operations, dropped loads, and injuries from tools or lifted materials. The safe practices emphasize having the proper tools, permits and inspections, conducting meetings, maintaining distances, and stopping work if unsafe conditions arise.

Uploaded by

Mark Roger Huberit II
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 9

1.

Pre job planning and  All necessary tools &  Ensure that appropriate permit to
preparation equipment available and in work is in place and work site
good condition and thoroughly inspected, get familiar with
functioning. other obstruction.
 Heat stress if work carried out  Conduct tool box meeting and explain
during summer. expected hazards and necessary
 Simultaneous/conflicting precautions.
operation, condition such  All necessary tools & equipment
loading/unloading, rig working available and in good condition and
near by proper functioning.
Grinding/Welding/Lifting/Cutti  Maintain a comfortable distance from
ng old line at work site. different work activities, be more
attentive make aware of your work to
other crew.
 Maintain minimum distance of 4 meters
from overhead power line.
 Check surrounding area, ground
condition, wind condition, overhead
power lines.

 Check lifting capacity of Crane and


radius of operation.
 Ensure Crane is placed on hard, level
ground, outriggers fully extended and
placed under timber mats.
 Ensure the Crane is having spark
arrester when working in restricted
area
2.Setting Crane for the load to  Hand Injury to the rigger.  Keep hands out of pinch point while
be lifted  Failure of slings or D-shackles. rigging, Use hand gloves.
 Know the weight to be lifted and its
Sequence of Job Components & Potential Hazards, Concerns Safe Practice/Procedure
configuration, Check Weather
Tasks condition ,
Wind speed(low, high)
7.Clean work site, Work  Incorrect placing  Correct
Emphasis more item.
missing to STOP WORK if they
Completed, final thorough check see anything unsafe.
 Remove all surplus supports, pipes,
up, hand over trashes.
3.Lifting the load  Lifted material falling.  Barricade the area of Crane operation
 Hitting people or existing place warning.
I THEREFORE UNDERSTAND AND AGREE TO THIS PROCEDURE AND SAFETY MEASURE THERE IN AND FULLY AWARE OF MY DUTIES AND
RESPONSIBILITIES AND I HAVE REVIEWED JSA AT SITE AND DISCUSSED WITH ALL WORKERS
SIGNATURE OF PERMIT USER:
1 6
2 7
3 8
4 9
5 10
11 18
12 19
13 20
14 21
15 22
16 23
17 24
25 32
26 33
27 34
28 35
29
30
31

You might also like