Scribd
Upload
199 views9 pages

Huawei RTN380H MW Link Setup Guide

This document provides instructions for configuring an MW link in a Huawei RTN380H router. It outlines the following steps: 1. Connect to the WiFi network with a name starting with "EMN" and password "Modify_123". 2. Open the web LCT interface using username "admin" and password "Changeme_1234". 3. Perform a NE search by WiFi, enter username "root" and password "Changeme_123" to find the local IP address. 4. Click on configuration and rename the link, then apply the changes.

Uploaded by

AbdalraheemAlqamati
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
199 views9 pages

Huawei RTN380H MW Link Setup Guide

This document provides instructions for configuring an MW link in a Huawei RTN380H router. It outlines the following steps: 1. Connect to the WiFi network with a name starting with "EMN" and password "Modify_123". 2. Open the web LCT interface using username "admin" and password "Changeme_1234". 3. Perform a NE search by WiFi, enter username "root" and password "Changeme_123" to find the local IP address. 4. Click on configuration and rename the link, then apply the changes.

Uploaded by

AbdalraheemAlqamati
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 9

HOW TO CONFIGURATION MW LINK IN HUAWEI

(RTN380H)

Authors: ENG. Abdraheem Elgmati


Technical: Ahmed Aljieidi
∑ After installation before turn ON the MW
∑ Search Network Wi-Fi if you are in POP site you will find a lot of Wi-Fi network just try to
write all the Wi-Fi shown in your network will find the name start with
∑ EMn- Serial Number EX(EMN-7216…….)
∑ Password for the network is
∑ Modify_123
∑ Open Web LCT its already added in Serve
∑ It wil move you to internet explorer
∑ User Name :admin
∑ Password:Changeme_1234
Click in NE Search
Choose NE Search By WI FI
User Name :root
Password:Changeme_123
Choose your local IP Address than click Apply
∑ Rename your LINK
∑ Click configuration than NE attribute change the name press Apply
∑ Open link budget start configuration
1. Basic parameters for XPIC
2. IF for IF channel bandwidth, modulation Mode
3. RF TX frequency ,T/R spacing, TX power ,power to be received
∑ You can check your dbm in Actual RX power

You might also like