Scribd
Upload
64 views1 page

Metallurgical Testing Protocol

This document outlines the qualification requirements for a thick section pipe made of ASTM A 995 Gr. 4A/MDS D46 steel for a NORSOK M-650 application. It specifies that tensile, impact, hardness/chemical/microstructure/ferrite, and pitting specimens must be taken from the quarter thickness location of the pipe for qualification testing.

Uploaded by

commando
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
64 views1 page

Metallurgical Testing Protocol

This document outlines the qualification requirements for a thick section pipe made of ASTM A 995 Gr. 4A/MDS D46 steel for a NORSOK M-650 application. It specifies that tensile, impact, hardness/chemical/microstructure/ferrite, and pitting specimens must be taken from the quarter thickness location of the pipe for qualification testing.

Uploaded by

commando
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

NORSOK M-650 QUALIFICATION

ASTM A 995 Gr. 4A/MDS D46

LOCATION: THICK SECTION - T/4

1. TENSILE SPECIMEN

2. IMPACT SPECIMEN

3.HARDNESS/CHEMICAL/MICRO/FERRITE SPECIMEN

4. PITTING SPECIMEN

You might also like