Scribd
Upload
94 views1 page

Auto Techs Security Systems: Programming Procedure #21031

The document provides instructions for programming remote transmitters for a vehicle security system. It is an 11 step process where the user presses buttons on the remote and ignition within timed windows to activate programming mode and add transmitters one by one, with a maximum of 3 transmitters able to be programmed.

Uploaded by

Ronald Yucra Cadena
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
94 views1 page

Auto Techs Security Systems: Programming Procedure #21031

The document provides instructions for programming remote transmitters for a vehicle security system. It is an 11 step process where the user presses buttons on the remote and ignition within timed windows to activate programming mode and add transmitters one by one, with a maximum of 3 transmitters able to be programmed.

Uploaded by

Ronald Yucra Cadena
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Auto Techs Security Systems

Website: www.AutoTechs.com
E-mail: support@autotechs.com
Address: 3732 Grissom Ln.
Kissimmee, Florida, 34741
407-870-8816

Following instructions are only for your remote, make sure you are doing those
steps precisely, if you have any questions,
please call 407-870-8816 for free tech support.

Programming Procedure #21031

1. Switch ignition on (run position).

2. Within 4 seconds press lock button on the first remote transmitter for 1 second.

3. Within 4 seconds you must switch ignitions off, (some models accessory position).

4. Within 4 seconds you must switch ignition on (run position).

5. Repeat steps 2, 3, and 4, twice, (or three times for some models).

6. Within 4 seconds press lock button of first remote transmitter for 1 second.

7. System should now lock and unlock vehicle indicate programming mode activated.

8. Within 10 seconds press lock button of first remote, vehicle doors will lock and
unlock.

9. Press lock button on each remaining remote to be programmed, allowing doors to lock
and unlock once as each remote is programmed.

10. Switch ignition off and remove key.

11. Check operation of all programmed remote transmitters.

***** A maximum of 3 remote transmitters can be programmed.

Auto Tech Security Systems shall not be held responsible for any type of damage, intentional or
otherwise, caused by the use of the programming instructions and guidance. Auto Tech Security
Systems is not responsible for any type of harm, whether physical or otherwise, due to correct or
incorrect use of procedures or techniques provided for transmitter programming. No liabilities for
any use of the programming instructions and/or telephone guidance are assumed whatsoever for
any cost, claims or damages filed for or caused by correct or incorrect use of the information
provided for programming.
©2006 AutoTech Security Systems

You might also like