Scribd
Upload
32 views3 pages

Fluid Mechanics Ii

This document is an assignment document for a fluid mechanics course titled Assignment A. It contains the course title, lecturer's name, a list of 4 students with their names and ID numbers, and a conclusion section summarizing the solving of a task using calculations based on pipe design and arrangements to plot pump performance curves and determine the operating points for pumps A and B. The conclusion found that pump B's operating point was only greater than pump A's by a factor of 1.7, not 2 as the boss had stated.

Uploaded by

Haziq Pazli
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
32 views3 pages

Fluid Mechanics Ii

This document is an assignment document for a fluid mechanics course titled Assignment A. It contains the course title, lecturer's name, a list of 4 students with their names and ID numbers, and a conclusion section summarizing the solving of a task using calculations based on pipe design and arrangements to plot pump performance curves and determine the operating points for pumps A and B. The conclusion found that pump B's operating point was only greater than pump A's by a factor of 1.7, not 2 as the boss had stated.

Uploaded by

Haziq Pazli
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

FLUID MECHANICS II

MEC 442

EMD4M12

TITLE :
Assignment A

LECTURER’S NAME: PN ROSNADIAH BAHSAN

No NAME ID NO
1. MUHAMMAD HAZIQ BIN MOHD PAZLI 2016229324
2. DANISH AIMAN BIN ZULKIFLI 2016218568
3. AHMAD HAZIQ DANIAL BIN YUSAINI 2016218526
4. MUHAMMAD IMRAN BIN HASHIM 2016218382
CONCLUSSION

As conclusion, we solved the task by using some calculation which is based on


the design and arrangements of pipe. Thus we can plotted pump performance curved
based on the graph head(m) vs volume flow rate(Q). The operating point for both
pump A and pump B is obtained by intersection point of Head available with Head
required . The operating point for Pump A is 12.6 Lpm and operating point for Pump
B is 21.36 Lpm respectively. As a result, we have meet boss requirement which is the
operating point for Pump B is greater than Pump A but the increase is only at the
factor of 1.7 which is lesser than the factor of 2. Thus, the boss’s statement is not very
accurate as the pump B does not have an operating point by a factor greater than 2.
REFERENCES

You might also like