Specifications Model Numbers
Supply Voltage PZR Red LED Light Source w/ 6’ Cable
• 10 to 24 VDC *PZRC Red LED Light Source w/ Connector
• Polarity Protected PZI IR LED Light Source w/ 6’ Cable
Current Requirements
*PZIC IR LED Light Source w/ Connector
• 50 mA (exclusive of load)
Output Transistors
• (1) NPN and (1) PNP sensor *M8 Nano Connectors The EZ-EYE™ photoelectric sensor by TRI-TRONICS® fulfills
output transistor Use GEC or RGEC Series Cables
the need for an affordable push button sensor that is EZ to align
• Sensor’s output can sink or
source up to 150 mA (current limited) and EZ to adjust.
• All outputs are continuously short-circuit protected
Response Time Features and Benefits:
• Light State response = 500 µs (microseconds)
• Dark State response = 500 µs (microseconds)
• EZ to adjust...AUTOSET routine requires a single push of
LED Light Source a button.
• Red = 660 NM • EZ to align...Flash Rate Indicator monitors received light intensity.
• Infrared = 880 NM • EZ to select higher excess gain...Tap the button twice to increase
• Pulse Modulated excess gain (sensitivity).
Push Button Control
(Note: Initiating the AUTOSET routine followed by tapping the
• AUTOSET Routine: Push and release with sensor in “light” state
• Excess Gain Adjustment: Tap twice to step to higher excess gain button emulates a screw driver adjustment.)
• Push and hold to activate flash rate alignment indicator • EZ to select sensing mode...Choose from ten completely
• Light /Dark “ON” selection: Tap 5 times to toggle interchangable optical blocks.
Range • EZ-EYE™ sensors are available with either infrared (IR) or red
• Dependant on optical block (Visit ttco.com for details)
LED light sources.
Hysteresis
• Approximately 15% of signal • All EZ-EYE™ sensors are equipped with both NPN an PNP
Light Immunity output transitors.
• Responds to sensor’s pulse-modulated light source, resulting in high immunity • Power supply requirements: 10 to 24 VDC
to most ambient light, including high intensity strobes. • Responds to sensor’s pulsed modulated light source...immune
Diagnostic Indicators
• Dual Red/Green LED: to most ambient light.
Red = Output Status
NOTE: If Output LED flashes, a short circuit condition exists.
Green = Flash Rate Alignment Indicator
• Dual Green/Amber LED:
Green = “ON” After Autoset Routine
Amber = “ON” After Excess Gain Adjustment
Ambient Temperature
• -40°C to 70°C (-40°F to 158°F)
Rugged Construction
• Chemical resistant, high impact polycarbonate housing
• Waterproof ratings: NEMA 4, IP67
P.O. Box 25135, Tampa, FL 33622-5135
RoHS Compliant
Tel (813) 886-4000 / Fax (813) 884-8818 Product subject to change without notice
info@ttco.com
ttco.com
4 070-0167 Rev 12
2 3
