0% found this document useful (0 votes)
183 views6 pages

LLDP

The document provides details about the configuration and status of port 1/2/3 on a switch. Key details include: - The port is operational at 1Gbps in full duplex mode - The port has transmitted 11210 octets and 117 packets with no errors - The attached SFP transceiver is operational and identifies the vendor and serial number

Uploaded by

Rango Tango
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
183 views6 pages

LLDP

The document provides details about the configuration and status of port 1/2/3 on a switch. Key details include: - The port is operational at 1Gbps in full duplex mode - The port has transmitted 11210 octets and 117 packets with no errors - The attached SFP transceiver is operational and identifies the vendor and serial number

Uploaded by

Rango Tango
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 6

RP/0/RP0/CPU0:xrv1#show lldp

Thu Feb 6 14:21:05.990 UTC


Global LLDP information:
Status: ACTIVE
LLDP Chassis ID: 0040.0b28.eaf7
LLDP Chassis ID Subtype: MAC Address (IEEE 802-2001) Chassis Subtype
LLDP System Name: xrv1
LLDP advertisements are sent every 30 seconds
LLDP hold time advertised is 120 seconds
LLDP interface reinitialisation delay is 2 seconds

RP/0/RP0/CPU0:xrv1#show lldp interface


Thu Feb 6 14:09:39.056 UTC

GigabitEthernet0/0/0/2:
Tx: enabled
Rx: enabled
Tx state: IDLE
Rx state: WAIT FOR FRAME

GigabitEthernet0/0/0/1:
Tx: enabled
Rx: enabled
Tx state: IDLE
Rx state: WAIT FOR FRAME
RP/0/RP0/CPU0:xrv1#

RP/0/RP0/CPU0:xrv1#show interfaces GigabitEthernet 0/0/0/1


Thu Feb 6 14:11:00.371 UTC
GigabitEthernet0/0/0/1 is up, line protocol is up
Interface state transitions: 1
Hardware is GigabitEthernet, address is 5254.00c2.74f4 (bia 5254.00c2.74f4)
Internet address is 10.1.3.2/24
MTU 1514 bytes, BW 1000000 Kbit (Max: 1000000 Kbit)
reliability 255/255, txload 0/255, rxload 0/255
Encapsulation ARPA,
Duplex unknown, 1000Mb/s, link type is force-up
output flow control is off, input flow control is off
loopback not set,
Last link flapped 19:45:43
ARP type ARPA, ARP timeout 04:00:00
Last input 19:22:58, output 00:00:00
Last clearing of "show interface" counters never
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
503 packets input, 45776 bytes, 0 total input drops
0 drops for unrecognized upper-level protocol
Received 1 broadcast packets, 0 multicast packets
0 runts, 0 giants, 0 throttles, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
25343 packets output, 2340240 bytes, 0 total output drops
Output 1 broadcast packets, 0 multicast packets
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions

A:SR1# //
INFO: CLI #2052: Switching to the MD-CLI engine

[]
A:admin@SR1# edit-config exclusive
INFO: CLI #2060: Entering exclusive configuration mode
INFO: CLI #2061: Uncommitted changes are discarded on configuration mode exit

(ex)[]
A:admin@SR1# configure port 1/2/3

(ex)[configure port 1/2/3]


A:admin@SR1# info
admin-state enable
ethernet {
mtu 1514
lldp {
dest-mac nearest-bridge {
receive true
transmit true
tx-tlvs {
port-desc true
sys-name true
sys-cap true
}
tx-mgmt-address system {
admin-state enable
}
}
}
}

(ex)[configure port 1/2/3]


A:admin@SR1#

A:SR1# show port 1/2/3

==============================================================================
=
Ethernet Interface
==============================================================================
=
Description : 10/100/Gig Ethernet SFP
Interface : 1/2/3 Oper Speed : 1 Gbps
Link-level : Ethernet Config Speed : 1 Gbps
Admin State : up Oper Duplex : full
Oper State : up Config Duplex : full
Physical Link : Yes MTU : 1514
Single Fiber Mode : No Min Frame Length : 64 Bytes
IfIndex : 37847040 Hold time up : 0 seconds
Last State Change : 02/06/2020 14:02:17 Hold time down : 0 seconds
Last Cleared Time : N/A DDM Events : Enabled
Phys State Chng Cnt: 1
RS-FEC Config Mode : None RS-FEC Oper Mode : None

Configured Mode : network Encap Type : null


Dot1Q Ethertype : 0x8100 QinQ Ethertype : 0x8100
PBB Ethertype : 0x88e7
Ing. Pool % Rate : 100 Egr. Pool % Rate : 100
Ing. Pool Policy : n/a
Egr. Pool Policy : n/a
Net. Egr. Queue Pol: default
Egr. Sched. Pol : n/a
Monitor Port Sched : Disabled
Monitor Agg Q Stats: Disabled
Auto-negotiate : true MDI/MDX : unknown
Oper Phy-tx-clock : not-applicable
Accounting Policy : None Collect-stats : Disabled
Acct Plcy Eth Phys : None Collect Eth Phys : Disabled
Egress Rate : Default Ingress Rate : Default
Load-balance-algo : Default LACP Tunnel : Disabled
Access Bandwidth : Not-Applicable Booking Factor : 100
Access Available BW: 0
Access Booked BW : 0
Sflow : Disabled

Suppress Threshold : 2000 Reuse Threshold : 1000


Max Penalties : 16000 Max Suppress Time: 20 seconds
Half Life : 5 seconds

Down-when-looped : Disabled Keep-alive : 10


Loop Detected : False Retry : 120
Use Broadcast Addr : False

Sync. Status Msg. : Disabled Rx Quality Level : N/A


Tx DUS/DNU : Disabled Tx Quality Level : N/A
SSM Code Type : sdh

Down On Int. Error : Disabled DOIE Tx Disable : Disabled

CRC Mon SD Thresh : Disabled CRC Mon Window : 10 seconds


CRC Mon SF Thresh : Disabled

EFM OAM : Disabled EFM OAM Link Mon : Disabled


Ignr EFM OAM State : False

Configured Address : 52:54:00:88:46:55


Hardware Address : 52:54:00:88:46:55

Transceiver Data

Transceiver Status : operational


Transceiver Type : SFP
Model Number : 3HE00028AAAA01 ALA IPUIAEMDAA
TX Laser Wavelength: 1310 nm Diag Capable : yes
Connector Code : LC Vendor OUI : 00:00:5f
Manufacture date : 2006/01/12 Media : Ethernet
Serial Number : 5ZS600H01693
Part Number : SCP6F44-A4-AWH
Optical Compliance : GIGE-LX
Link Length support: 10km for SMF; 550m for OM2 50u MMF; 550m for OM1 62.5u M*

==============================================================================
=
Transceiver Digital Diagnostic Monitoring (DDM), Internally Calibrated
==============================================================================
=
Value High Alarm High Warn Low Warn Low Alarm
-------------------------------------------------------------------------------
Temperature (C) +22.8 +105.0 +95.0 -45.0 -45.0
Supply Voltage (V) 3.33 4.00 3.60 3.00 2.80
Tx Bias Current (mA) 6.0 60.0 50.0 0.0 0.0
Tx Output Power (dBm) -5.34 0.00 -2.00 -10.50 -12.50
Rx Optical Power (avg dBm) -40.00 8.16 8.16 -40.00 -40.00
==============================================================================
=
==============================================================================
=
* indicates that the corresponding row element may have been truncated.

==============================================================================
=
Traffic Statistics
==============================================================================
=
Input Output
-------------------------------------------------------------------------------
Octets 0 11210
Packets 0 117
Errors 0 0
Utilization (300 seconds) 0.00% 0.00%

==============================================================================
=
Port Statistics
==============================================================================
=
Input Output
-------------------------------------------------------------------------------
Unicast Packets 0 0
Multicast Packets 0 115
Broadcast Packets 0 2
Discards 0 0
Unknown Proto Discards 0
==============================================================================
=

==============================================================================
=
Ethernet-like Medium Statistics
==============================================================================
=

Alignment Errors : 0 Sngl Collisions : 0


FCS Errors : 0 Mult Collisions : 0
SQE Test Errors : 0 Late Collisions : 0
CSE : 0 Excess Collisns : 0
Too long Frames : 0 Int MAC Tx Errs : 0
Symbol Errors : 0 Int MAC Rx Errs : 0
In Pause Frames : 0 Out Pause Frames : 0
==============================================================================
=

You might also like