เฉลยแล็ป Packet Activity Document No.
:
ART-CNA-003-L31
CCNA LAB 3-1: Point-to-Point Protocol (PPP) - PAP
[ตัง้ ค่ าที่ Ranet BR1 (คลิกที่เครื่ อง console)] :
(ไปยังแท๊ บ Desktop > คลิก Terminal > กด OK)
Ranet-BR1>en
Ranet-BR1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Ranet-BR1(config)#int fa0/0
Ranet-BR1(config-if)#no sh
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Ranet-BR1(config-if)#ip add 192.168.0.62 255.255.255.224
Ranet-BR1(config-if)#int s0/0/0
Ranet-BR1(config-if)#no sh
%LINK-5-CHANGED: Interface Serial0/0/0, changed state to down
Ranet-BR1(config-if)#ip add 192.168.0.225 255.255.255.252
Ranet-BR1(config-if)#encapsulation ppp
Ranet-BR1(config-if)#ppp authentication pap
Ranet-BR1(config-if)#ppp pap sent-username ranetpapuser password ranetpappass
Ranet-BR1(config-if)#exit
Ranet-BR1(config)#username ranetpapuser password ranetpappass
Ranet-BR1(config)#
Ranet-BR1#
%SYS-5-CONFIG_I: Configured from console by console
Ranet-BR1#copy run start
Destination filename [startup-config]?
Building configuration...
[OK]
Ranet-BR1#
1
A R T I C L E
[ตัง้ ค่ าที่ Ranet BR2 (คลิกที่เครื่ อง console)] : Document No.:
(ไปยังแท๊ บ Desktop > คลิก Terminal > กด OK) ART-CNA-003-L31
Ranet-BR2>en
Ranet-BR2#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Ranet-BR2(config)#int fa0/0
Ranet-BR2(config-if)#no sh
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Ranet-BR2(config-if)#ip add 192.168.0.78 255.255.255.240
Ranet-BR2(config-if)#int s0/0/0
Ranet-BR2(config-if)#no sh
%LINK-5-CHANGED: Interface Serial0/0/0, changed state to up
Ranet-BR2(config-if)#clock rate 64000
Ranet-BR2(config-if)#ip add 192.168.0.226 255.255.255.252
Ranet-BR2(config-if)#encapsulation ppp
Ranet-BR2(config-if)#ppp authentication pap
Ranet-BR2(config-if)#ppp pap sent-username ranetpapuser password ranetpappass
Ranet-BR2(config-if)#exit
Ranet-BR2(config)#username ranetpapuser password ranetpappass
Ranet-BR2(config)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0/0, changed state to up
Ranet-BR2(config)#
Ranet-BR2#
%SYS-5-CONFIG_I: Configured from console by console
Ranet-BR2#copy run start
Destination filename [startup-config]?
Building configuration...
[OK]
Ranet-BR2#
[ไปยังเครื่ อง Host1] :
(ไปยังแท๊ บ Desktop > คลิกไอคอน Command Prompt)
2
A R T I C L E
Packet Tracer PC Command Line 1.0 Document No.:
PC>ping 192.168.0.70 ART-CNA-003-L31
Pinging 192.168.0.70 with 32 bytes of data:
Reply from 192.168.0.70: bytes=32 time=13ms TTL=126
Reply from 192.168.0.70: bytes=32 time=13ms TTL=126
Reply from 192.168.0.70: bytes=32 time=11ms TTL=126
Reply from 192.168.0.70: bytes=32 time=11ms TTL=126
Ping statistics for 192.168.0.70:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 11ms, Maximum = 13ms, Average = 12ms
PC>
3
A R T I C L E
