Scribd
Upload
59 views1 page

Junction Box IC-315 Guide

The document provides instructions for connecting a distress alert/received call unit and other units to a junction box. The junction box can connect a maximum of four units. Cables are connected by removing the box cover and inserting cables into terminals. Approved cable types are listed. Labels indicate cable connections for different units. Diagrams show the cable connection procedure and cable clamp replacement. Input and output sentences for the connected navigator are also listed.

Uploaded by

gopal sengar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
59 views1 page

Junction Box IC-315 Guide

The document provides instructions for connecting a distress alert/received call unit and other units to a junction box. The junction box can connect a maximum of four units. Cables are connected by removing the box cover and inserting cables into terminals. Approved cable types are listed. Labels indicate cable connections for different units. Diagrams show the cable connection procedure and cable clamp replacement. Input and output sentences for the connected navigator are also listed.

Uploaded by

gopal sengar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

2.

WIRING

2.4 Junction Box IC-315


Use the junction box IC-315 to connect the distress alert/received call unit
IC-305 and other unit (max. four units) to the terminal unit.
Unfasten four screws to remove the box cover to connect cables.

For connection, use the optional 5 pair cable CO-SPEVV-SB-C 0.2x5P, JIS cable
(Japan Industrial Standards) TTYCS-4 or equivalent. When using the
CO-SPEVV-SB-C 0.2x5P cable, replace the cable clamp with the cable clamp
16-018-6008-1, supplied with IC-315.
1 Vcc

IC-305/306
2 GND
3 TD/RD-A
4 TD/RD-B
Cover 5 NC
6 TD-A(NAV) 1
7 TD-B(NAV) 2
8 RD-A(NAV)
9 RD-B(NAV)
10 GND
11 DMC OUT-H
Cable clamp 12 DMC OUT-C
13 DMC IN-H
14 DMC IN-C 3 Core 7 mm
15 DMC CTR
Terminal
board Sticker for
To terminal unit
connection of
other equipment
Procedure
1. Insert driver from direction 1 .
2. Tilt slightly toward 2 .
3. Insert cable core to 3 .

4. Pull out the driver.


Note 1: Do not insert the cable deeply
to prevent pinching the cable sheath.

Note 2: Pull the cable slightly to confirm


the tightening

Junction Box IC-315


Input/output sentences
The following sentences can be input/output with the navigator connected.
Input sentences Output sentences
GGA, GLL, VTG, WPL, RMA, RMB,
RMC, MTW, DBT, BWC, BWR, VDR, GGA, ZDA, GLL, VTG, RMC, GSV
ZDA

17

You might also like