Scribd
Upload
469 views2 pages

DE10-Nano: Quick Start Guide

This document provides a quick start guide for the DE10-Nano board. It includes what is in the box, how to boot the board by setting switches and inserting a microSD card, and how to interact with the board by connecting a USB cable from the board to a PC.

Uploaded by

Leonardo Muñoz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
469 views2 pages

DE10-Nano: Quick Start Guide

This document provides a quick start guide for the DE10-Nano board. It includes what is in the box, how to boot the board by setting switches and inserting a microSD card, and how to interact with the board by connecting a USB cable from the board to a PC.

Uploaded by

Leonardo Muñoz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

DE10-Nano

Quick Start Guide

FPGA
Cyclone V
HPS SoC FPGA LTC 2x7 Header
System 5CSEBA6U23I7
2x20 GPIO (FPGA) DDR3
FPGA
Configuration USB OTG
Mode Switch (USB Micro-AB)

UART to USB
Arduino Header (USB Mini-B)
5V DC
Power Jack Ethernet RJ45
EPCS 128
G-Sensor
HDMI-TX Analog-to-digital
converter
Clock Generator
LED x8

USB Blaster II 2x5 ADC Header


(USB Mini-B) Button x2
User LED
MicroSD Card User Button
Socket HPS_RST
2x20 GPIO (FPGA) WARM_RST
Slide Switch x4

1
W hat’s in the Box?

1 2 1 DE10-Nano Board
2 DE10-Nano Quick Start Guide
3 Type A to Mini-B USB Cable x1
4 Type A to Micro-B USB Cable x1

6 5 Power DC Adapter (5V)


3 4 5 8
GB

6 microSD Card (installed)


7 7 Four Silicon Footstands
2
B ooting the board
To boot the board, follow these steps:

“0”
5V Power

O
N

Y
4
Adapter

SW10
1 2 3 4 5 6
“1”
0 1 2 3 4
MSEL
FPGA Configuration
8
GB
Mode Switch

MicroSD
Socket
User LED

1 Verify the FPGA Configuration Mode Switches are set to 01010, as shown above, to boot the
DE10-Nano board from the microSD Card
2 Make sure the microSD Card, included in the kit, is properly inserted
3 Connect the power adapter to the power jack on the DE10-Nano
4 After about 10 seconds, the user LED will begin to pulse like a heartbeat indicating that the
Linux OS has booted
3
I nteracting with the board

Micro-B USB Type A USB PC

USB cable

1 Connect the USB port on your PC to the board USB port by using the Type A to Micro-B
USB cable
2 Look for the DE10-Nano to appear as a USB mass storage device on your PC
3 Locate and open the START.HTML file stored on the DE10-Nano
4 Follow the instructions in the START.HTML file

You might also like