Scribd
Upload
44 views1 page

LNT Alsi12: Aluminium Solid Rod

This document summarizes information about LNT AlSi12 aluminum alloy welding wire, including its chemical composition, mechanical properties, physical properties, applications, classifications, general description, and approvals. It lists the alloy's typical chemical composition and mechanical properties when welded with an inert gas shield. Diameters and packaging sizes are also provided.

Uploaded by

sorin robert
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
44 views1 page

LNT Alsi12: Aluminium Solid Rod

This document summarizes information about LNT AlSi12 aluminum alloy welding wire, including its chemical composition, mechanical properties, physical properties, applications, classifications, general description, and approvals. It lists the alloy's typical chemical composition and mechanical properties when welded with an inert gas shield. Diameters and packaging sizes are also provided.

Uploaded by

sorin robert
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

www.lincolnelectric.

eu
455
All information in this data sheet is accurate to the best of our knowledge at the time of printing. Please refer to www.lincolnelectric.eu for any udpated information.
Fumes: Material Safety Data Sheets (MSDS) are available on our website.

LNT AlSi12
LNT AlSi12: rev. EN 22
Packaging and available sizes
Diameter (mm) 2.0 2.4 3.2 4.0 Note : Cut length = 1000 mm
Unit : 5 kg tube X X X X
aluminium solid rod
CHEMICAL COMPOSITION (W%) TYPICAL WIRE
Al Si Fe Cu Mn Mg Cr Zn Ti Be
bal. 11-13 max. 0.6 max. 0.30 max. 0.15 0.10 0 max. 0.20 max. 0.15 max. 0.0003
Notes : Unspecified elements should not exceed a total of 0.15%
Mechanical properties. typical. all weld metal
Shielding
gas Condition
Yield strength
(N/mm2)
Tensile strength
(N/mm2)
Elongation
(%)
Typical values I1 AW 60-80 130-190 5-20
physical properties
Melting range : 573 - 585°C
Density : approximately 2680 kg/m3
mat erial to be welded
Refer to “Filler Metal Guide for Aluminium”
APPLICATIONS
For welding 6XXX alloys. and most casting alloys
Automotive components , radiators and air conditionning
Classificat ion
AWS A5.10/5.10M - R4047
ISO 18273 - S AI 4047A (AlSi12)
EN 573.3 - EN AW-AlSi12
AA - 4047
Werkstoff Nr. - 3.2585
General description
Lower melting point and higher fluidity than 4043 wires
Can be used as a substitute for 4043 to increase silicon content in the weld metal and minimize hot cracking and produce higher
fillet weld shear strength
Can be used as a brazing alloy
Other sizes and packaging on request
APPROVALS
CE
+
Shielding gases (acc. ISO 14175)
I1
Flow Rate
: Inert gas Ar (100%)
: 8 - 15 L/min

You might also like