Scribd
Upload
22K views1 page

16.work Instruction For VMC

This document provides work instructions for using a VMC turning center. It outlines initial machine settings like assembling fixtures, checking for debris, and ensuring the coolant system is working. It describes tools, inserts, and consumables used like tool holders, general machining inserts, coolant oil, and lubrication oil. The instructions explain setting tools according to the job, checking dimensions, and noting inspection details in reports while referring to documents like SOPs, control plans, and process flow diagrams.

Uploaded by

SAKTHIVEL A
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
22K views1 page

16.work Instruction For VMC

This document provides work instructions for using a VMC turning center. It outlines initial machine settings like assembling fixtures, checking for debris, and ensuring the coolant system is working. It describes tools, inserts, and consumables used like tool holders, general machining inserts, coolant oil, and lubrication oil. The instructions explain setting tools according to the job, checking dimensions, and noting inspection details in reports while referring to documents like SOPs, control plans, and process flow diagrams.

Uploaded by

SAKTHIVEL A
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

WORK INSTRUCTION FOR

Doc.. No.: SSE/WI/16


VMC TURNING CENTRE
Revision No. : 01
Revision Date : 10.09.2018

INITIAL SETTING:
 Assemble required Fixture , wise into machine.
 Check the machine for dust, dirt, chips wipes the same.
 Check coolant oil pump working condition.
 Check the oil level in the Hydraulic Tank.

INSTRUMENT USED:
 Micrometer, Vernier caliper, Digital Vernier, and Bore Plug Gauge.
TOOLS USED:
 Tool Holders of Different Types, Spanners and Allen key.
INSERTS USED:
 General Machining Inserts, End mills, cutter, Form Tool.
CONSUMABLES USED:
Cotton Waste, Coolant Oil, Lubrication Oil.
TOOL SETTINGS:
 Set the End mill, Drill, inserts according to the Job to be processed in the machine and get approved
from the Production I/C.

OPERATION:
 Ensure the Proper Program Number, Check the RPM & Feed
 Go to home reference before start the work.
 Load the machine with inspected raw material in the soft jaws and start the machine.
 Check the dimensions of the setting piece and get oral approval from the Production I/C and continue.
 Check the required dimension from control plan and note in the In process inspection report.
 Check the process parameters as per control plan and note down it in the In process Inspection report.

REFERANCE DOCUMENTS:
 In process inspection report
 SOP/Control plan.
 Process Flow Diagram.

Page No

Prepared By Approved By 01 of 01

You might also like