Scribd
Upload
75 views1 page

Task Sheet 1.5-1

The document provides the procedure for removing contact breaker points from a vehicle's distributor. It lists the necessary supplies which include tools, testing equipment, and vehicle parts. The 8 step procedure instructs to prepare tools, release screws to lift the distributor cap, disconnect wiring at the contact point terminal, remove any screws or nuts holding the assembly, remove connections from the terminal post, and clean any protective coating off new contact points. Technicians will be assessed through written or oral questioning and a performance criteria checklist.

Uploaded by

Mario Tolo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
75 views1 page

Task Sheet 1.5-1

The document provides the procedure for removing contact breaker points from a vehicle's distributor. It lists the necessary supplies which include tools, testing equipment, and vehicle parts. The 8 step procedure instructs to prepare tools, release screws to lift the distributor cap, disconnect wiring at the contact point terminal, remove any screws or nuts holding the assembly, remove connections from the terminal post, and clean any protective coating off new contact points. Technicians will be assessed through written or oral questioning and a performance criteria checklist.

Uploaded by

Mario Tolo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

TASK SHEET 1.

5-1

Title: Procedure In Removing The Contact Breaker Point

Performance Objective: Given the ACTIVITY SHEET 1.5-1, you


should be able to perform procedure in
removing the contact breaker point

Supplies/Materials Equipment : Activity Sheet 1.5-1, Handtools


and Power tools, Testing equipment, Distributor assembly, ignition coil
and condenser, Actual vehicle equipped with conventional ignition
System

Steps/Procedure:
Procedure in removing the contact breaker point
1. Prepare the tools and materials needed in removing the contact
breaker point.
Tools and materials needed:
 Hand tools and Power tools,
 Voltmeter
 Timing light
 Distributor test bench
 Distributor assembly
 Ignition coil and condenser
 Actual vehicle equipped with conventional ignition System
2. Rerelease each screw in turn and then lift the cap.
3. Disconnect the wiring at the contact-breaker terminal post.
4. Connections may be a press-on fit or held by nuts.
5. Undo the screw or screws holding the assembly and lift it off.
6. Remove the nut from the threaded top of the terminal post, and
take off the connections.
7. The contact faces of the new points may be covered by a
protective coating.
8. Wash it off with petrol or paraffin, and dry.

Assessment Method:

Written - Oral Questioning


Performance Criteria checklist

You might also like