Scribd
Upload
1K views1 page

Evo-All Master Reset Procedure

The EVO-ALL master reset procedure resets all options back to default settings. To perform the reset, hold down the programming button while connecting the datalink connector. Release when the LED turns red, then hold the button again until the three LEDs alternate. Disconnect to complete the reset.

Uploaded by

fishhunter18
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views1 page

Evo-All Master Reset Procedure

The EVO-ALL master reset procedure resets all options back to default settings. To perform the reset, hold down the programming button while connecting the datalink connector. Release when the LED turns red, then hold the button again until the three LEDs alternate. Disconnect to complete the reset.

Uploaded by

fishhunter18
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

EVO-ALL MASTER RESET PROCEDURE

The master reset is very simple on the EVO-ALL, but be warned that a reset will also reset all the
options back to default. So if you have any special options enabled (such as the all famous D1
and C1 for 3x lock start), or if the vehicle programming requires the use of the DCryptor, make
sure that you have access to the Flash-Link Manager!

1. Hold down programming button while plugging in datalink connector.


2. Let go of button when LED is RED.
3. Push and hold button again until all three LEDs start to alternate.
4. Disconnect unit, she is now reset.

You might also like