Scribd
Upload
417 views1 page

JSA Welding & Cutting Works

Welding and cutting operations present fire, electric, and eye hazards. Before starting work, combustible materials must be removed from the area or protected. A fire extinguisher and fire watch are required. During welding, proper personal protective equipment including welding gloves and face shield must be worn to prevent injuries. Electrical cords and tools must be inspected for defects before use. A job safety analysis was conducted to identify hazards and required controls for preparatory operations and the welding/cutting work.

Uploaded by

Cherry Betonio
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as ODT, PDF, TXT or read online on Scribd
417 views1 page

JSA Welding & Cutting Works

Welding and cutting operations present fire, electric, and eye hazards. Before starting work, combustible materials must be removed from the area or protected. A fire extinguisher and fire watch are required. During welding, proper personal protective equipment including welding gloves and face shield must be worn to prevent injuries. Electrical cords and tools must be inspected for defects before use. A job safety analysis was conducted to identify hazards and required controls for preparatory operations and the welding/cutting work.

Uploaded by

Cherry Betonio
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as ODT, PDF, TXT or read online on Scribd
You are on page 1/ 1

Country Office / Project: JGC PENTHOUSE EXTENSION BLDG.

Tools and or Equipment required: JSA No:


Welders. Compressed Gasses,
Job Location & Details: Welding/Cutting Date Prepared:
Electrical Grinders.
JSA Participants: Approved by: HSE Manager

Responsible Supervisor:

Date:
HAZARDS IDENTIFIED (Eg.
JOB STEP CONTROLS REQUIRED (Eg. Remove overhead cable or isolate/sheath ACTION BY/RECORD
Electrocution from 11Kv
(Eg. Set Up Crane) overhead or monitor with spotter) Training PPE Needs (Eg. Supervisor)
Cables)
1. When practical, the object to be welded, cut, orb heated should Safety Engineer. Supervisor,
be moved to a designated safe location away from flammable Engineer.
liquids and other combustibles.
2. If the object cannot be moved, positive means must be taken to
confine the heat, sparks, and slag.
3. A 20 lb. ABC dry chemical extinguisher (or equivalent) must be
immediately available in the work area and must be maintained in
Fire a state of readiness for instant use.
Preparatory Operations Burns 4. Garbage and trash shall not be accumulate on the premises, as it
may be ignited by the sparks or slag
5. When welding is being performed on higher level where there is
an exposure to workers below, the ares directly below the welding
shall be cleared and marked as a “ Do Not Enter Zone”, to
protect any workers passing underneath from being hit by sparks
or slag.
6. A fire watch must be maintained at least 30 minutes after the hot
work is completed.
7. Welding/cutting operations shall be performed by trained certified
workers.
Welding Or Cutting Eye damage 1. During welding/cutting operations, proper welding gloves and a full- Safety Engineer. Supervisor,
Electric Shock face, UV -ray protective shield shall be worn to prevent injuries to Engineer.
Cuts & Burns operator.
2. All electrical cords shall be inspected and in good working condition
prior to use (no missing ground pins, no damaged cords, or frayed
wires evident).
3. All small tools shall be inspected prior to use and found to be in
good working order prior to use.

You might also like