Scribd
Upload
59 views4 pages

Arduino IoT Cloud for Beginners

This document provides instructions for an Arduino IoT Cloud bootcamp on detecting button presses. The bootcamp aims to teach detecting user events on an MKR board in the Arduino IoT Cloud and utilizing third party libraries in IoT applications. Participants will need an Arduino MKR WIFI 1010 board, USB cable, connecting wires, 1k ohm resistor, and push button switch to build a button input circuit and connect it to specific pins on the MKR board.

Uploaded by

Anand Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
59 views4 pages

Arduino IoT Cloud for Beginners

This document provides instructions for an Arduino IoT Cloud bootcamp on detecting button presses. The bootcamp aims to teach detecting user events on an MKR board in the Arduino IoT Cloud and utilizing third party libraries in IoT applications. Participants will need an Arduino MKR WIFI 1010 board, USB cable, connecting wires, 1k ohm resistor, and push button switch to build a button input circuit and connect it to specific pins on the MKR board.

Uploaded by

Anand Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Arduino IoT Cloud Bootcamp

Detecting a Button Press


Learning Objectives

• Detecting user events that occur on the MKR Board in the


Arduino IoT Cloud

• Utilizing Third Party Libraries in IoT applications


Parts needed

• Arduino MKR WIFI 1010 Board (or compatible board)

• USB Cable

• Connecting wires

• 1 k Ω resistor

• Push button switch


Button Thing

Component Other
MKR Pin
Connection Connection
5 Button Pin 1
Button Pin 1 Resistor
GND Resistor
VCC Button Pin 2

You might also like