We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 3
53.2
533
534
Inert Gas Generator
KANGRIM
Every 250 hrs
(Component Mainterance Description [Remarks
Pilot burner Dismount and clean oil nozzle Distance between electrodes
Part No. 0870 [Check and clean spark plug lapprox. 3~4 mm.
Main burner Dismount and clean oil nozzle
Part No. 0860 Check cone damage
[Fuel oil filter Drain sump Fuel off filter manual
IPart No. 6010
Tnstrument air filter Disassemble and efean
[Part No. 2620
Filter of pressure regulators
Part No. 0023, 0063,
(Clean filter element
Annually
[Component “Mainterance Description [Remarks
[Demister [Clean it
[Part No. 1300, 1310, 1320
[Water spray nozzles
inspect and clean IFnecessary
Part No. 1170
[Temperature & pressure Check the calibration
leauges
PLC battery Replace battery See replacing the PLC battery
PLC manual
Safety devices [Clean filter element See the settings in the part lists
After every stop
(Component Mainterance Description [Remarks
[Compbusion chamber
cooling jacket
[Rinse with fresh water
[DO NOT USE SALT WATER|
Replacing the PLC battery
The PLC is almost maintenance free. There are only a few points for maintenance.
‘The battery must be replaced every year. When the battery is not inserted, (or inserted in the
correct manner), the PLC will not work properly. Make sure there is always a spare battery on board
the ship for each CPU unit.
Replacement of the battery:
1. Make sure the power on the PLC is turned on (green or red light on),
2. Switch the RUN/STOP switch in position STOP, the red light will light up.
3. Pull the battery cover open and remove the battery by pulling the plastic strip, the yellow light
with light up.
4, Put the new battery in its place. Check the polarity.
5. The yellow light will go out. If not, the battery is defective or has been inserted incorrectly.
6. If the yellow light is out, switch the PLC to run mode. The red light will go out and the green light
will light up.
KANGRIM INDUSTRIES CO., LTD.
45 5.3.6
Lubricating
Inert Gas Generator
schedule
KaANGRIM
For lubricating instructions of the E-motors, consult the instructions in the Sub-suppliers documentati
[interval Driven end Every 800 hrs [Non driven end Every 800 hrs
[Component [E-motors, Part No. 10307 1040 [E-motors, Part No. 1030 7 1040
oy [See Motor L.O. chart [See Motor L.O.
Bearing type [See Motor technical table
Lubricant [See Motor L.O. chart
Reference [Sub-suppliers documentation
* Remark : If grease of another maker will be used it is recommended to remove the
consisting grease completely from the bearing(s) before the new grease
is used.
KANGRIM INDUSTRIES CO., LTD.
46 Inert Gas Generator KANGRIM
6. Some possible causes to faults
during start and operation
KANGRIM INDUSTRIES CO.,LTD.
