Scribd
Upload
568 views1 page

Installation Instructions: Remote Starter Solenoid Kit For GM Starters

The document provides installation instructions for a remote starter solenoid kit for GM starters. It involves disconnecting the battery cables, mounting the solenoid, marking and disconnecting wires from the original solenoid, connecting battery cables and lengthened wires between the new solenoid and starter solenoid, and testing the new solenoid.

Uploaded by

ronald allan livioco
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
568 views1 page

Installation Instructions: Remote Starter Solenoid Kit For GM Starters

The document provides installation instructions for a remote starter solenoid kit for GM starters. It involves disconnecting the battery cables, mounting the solenoid, marking and disconnecting wires from the original solenoid, connecting battery cables and lengthened wires between the new solenoid and starter solenoid, and testing the new solenoid.

Uploaded by

ronald allan livioco
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Remote Starter Solenoid Kit

For GM Starters
INSTALLATION INSTRUCTIONS

1. Disconnect both battery cables from the battery.


2. Find a suitable area to mount the solenoid (firewall, inner fender panel, or the frame). Drill two holes and mount the solenoid
using suitable fastners. Note: If mounting the solenoid to surfaces other than metal, a ground wire must be connected to the
solenoid mounting screw. The solenoid must be grounded!
3. Mark all wires at the starter solenoid and disconnect them.
4. Install the jumper on the starter solenoid, it will go on the battery and the "S" terminal.
5. Route original battery cable from the battery to one of the large terminals on the new solenoid. Route a second battery cable
from the other large terminal on the new solenoid to the battery terminal of the solenoid on the starter. Note: When routing
routing battery cables make sure they are not near exhaust or any sharp edges.
6. Locate the wires that originally went to the battery terminal of the starter solenoid. Lenghten the wire by adding the red
wire supplied in the kit to them and connect to the large terminal of the new solenoid that has the battery cable from the
battery connected to it. Caution: Any fusible links that were cut off must be reinstalled on the same wire before reconnecting.
7. Take the wire that went to the "S" terminal of the starter solenoid and lengthen it using the supplied purple wire. Route this
wire to the new solenoid and connect it to the "S" terminal.
8. If the vehicle has a wire on the "R" terminal of the solenoid at the starter, then lengthen it using the pink wire supplied and
connect it to the "I" terminal of the new solenoid.
9. Reconnect the battery cables and test the solenoid for proper operation.

S I
FUSIBLE
LINK

PURPLE
PINK
RED

BATTERY
JUMPER

POWER WIRES TO
MAIN WIRING

START WIRE FROM


IGNITION SWITCH

WIRE TO IGNITION
COIL (NON-HEI)

Allstar Performance 8300 Lane Dr., Watervliet, MI 49098


Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com

Form 1035 Rev. 011909

You might also like