Scribd
Upload
130 views1 page

Devireg 530

The document describes the DEVIregTM 530 electronic thermostat. It has a 2-pole switch and floor sensor to control floor temperature. It can be flush or surface mounted and has a dial to adjust the temperature setting. An LED indicates heating, standby or fault modes.

Uploaded by

Mohammed Al-kawak
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
130 views1 page

Devireg 530

The document describes the DEVIregTM 530 electronic thermostat. It has a 2-pole switch and floor sensor to control floor temperature. It can be flush or surface mounted and has a dial to adjust the temperature setting. An LED indicates heating, standby or fault modes.

Uploaded by

Mohammed Al-kawak
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

7.

Controls
Data
DEVIreg™ Sheet

DEVIreg™ 530
The DEVIreg™ 530 is a simple electronic thermostat with a 2-pole switch, using a floor
sensor (wire) to measure and control the desired floor temperature. It can be either flush-
mounted or surface-mounted.

The thermostat has a dial for adjusting the temperature setting with a scale from to 6.

Furthermore, the thermostat has an LED indicating the current mode (heating, standby or
fault).

Type Value
Benefits: Operation voltage 220 V- 240V~ 50/60 Hz
• 2-pole safety breaker Standby power consumption max. 0.25 W

• Low standby consumption Relay:


Resistive load Max 15A / 3450W @ 230V
• Sensor failure monitoring Inductive load Cos Φ = 0.3 max. 1A

• LED indication for fault Sensing unit NTC 15 kOhm at 25° C


Hysteresis ± 0.4° C
• Frost protection
Ambient temperature -10° C. to +30° C

Standard compliance: Frost protection 5° C -


Temperature range 5-45°C with floor sensor only
• EN/IEC 60730-1 (general) and
EN/IEC 60730-2-9 (thermostat) Cable specification max 1 x 4 mm2 or 2 x 2,5 mm2
Ball pressure test temperature 75° C

k H B d
Approvals: Pollution degree 2 (domestic use)
Controller type 1C
Storage temperature -20° C to +65°C
IP class 31
Protection class Class II -
Dimensions (H/W/D) 85 mm x 85 mm x 36 mm
Weight 90 g

Types
Item no. Product name Type EAN no.
140F1030 DEVIreg™ 530 With floor sensor and ELKO frame 5703466208991
140F1031 DEVIreg™ 530 With floor sensor and ELJO frame 5703466209004
140F1032 DEVIreg™ 530 With floor sensor and JUSSI frame 5703466209011
19150352 DEVIreg™ 530 10 pcs. pack with floor sensor and JUSSI frame 5703466152829
19150354 DEVIreg™ 530 10 pcs. pack with floor sensor and ELKO frame 5703466159248
93
Accessories and spare parts on page

Produced by Danfoss © 07/2015 VDIIH102 79

You might also like