Scribd
Upload
82 views1 page

Fieldlink: Terminator

This document provides information about a Foundation Fieldbus terminator. The terminator contains resistors and capacitors needed to terminate a Fieldbus segment and prevent signal reflections. It has a compact and durable design with a 100 ohm resistor and 1 microfarad capacitor. The terminator should be located at each end of a Fieldbus segment according to specifications.

Uploaded by

Hernan Humberto Castañeda Mendoza
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
82 views1 page

Fieldlink: Terminator

This document provides information about a Foundation Fieldbus terminator. The terminator contains resistors and capacitors needed to terminate a Fieldbus segment and prevent signal reflections. It has a compact and durable design with a 100 ohm resistor and 1 microfarad capacitor. The terminator should be located at each end of a Fieldbus segment according to specifications.

Uploaded by

Hernan Humberto Castañeda Mendoza
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

FieldLink process networking Foundation Fieldbus

Terminator
This Foundation Fieldbus terminator contains all of the components
Model number
required for terminating a Foundation Fieldbus segment. This device
AC461111A is designed to be very compact and easy to use. The terminator is used
to prevent reflections on the Fieldbus cable resulting from the ends
of the segment. One terminator should be located at each end of the
Fieldbus segment.
Features
• 100 ohm resistor • Compact, moisture resistant shell
• 1 microfarad capacitor

Specifications
Resistor 100 ohms +/-1%
Schematic drawing
Capacitor 1 micro farad +/- 5%
Housing material ABS
+
Pins 2 (not polarity sensitive)
Dimensions (L, W, H) 28mm, 14mm, 14mm
Operating temperature -40°C to + 80°C (-40ºF to 176ºF)

Dimensions (mm) Wiring diagram

+ –

1.218.739.5774 95 StoneL.com

You might also like