Scribd
Upload
31 views4 pages

Lab Report#3 - CS

This lab report summarizes 3 tasks completed in an introduction to Simulink basics course. Task 1 involved constructing an LTI model in Simulink and checking its step response. Task 2 called the Simulink file into the command window and converted it to a transfer function. Task 3 derived a transfer function for another given LTI model in Simulink. The report was submitted by Muhammad Fahad Siddiq for their Control Systems course at Air University, Islamabad.

Uploaded by

Fahad Siddiq
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
31 views4 pages

Lab Report#3 - CS

This lab report summarizes 3 tasks completed in an introduction to Simulink basics course. Task 1 involved constructing an LTI model in Simulink and checking its step response. Task 2 called the Simulink file into the command window and converted it to a transfer function. Task 3 derived a transfer function for another given LTI model in Simulink. The report was submitted by Muhammad Fahad Siddiq for their Control Systems course at Air University, Islamabad.

Uploaded by

Fahad Siddiq
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Lab Report# III

Course: Control Systems


Instructor: Sir. Hussain Asif
Submitted by: Muhammad Fahad Siddiq
ID:150271
Dated:7th October.2020

Department of Electrical Engineering


Faculty of Engineering
Air University, Islamabad

12 | P a g e
Lab#03
Introduction to Simulink Basics

Lab Tasks
Task#1:
Construct an LTI model of unity feedback system on the SIMULINK design
window using the SIMULINK library and then check its step response on the
scope for the system given below. For m=2, b=2 and K=10.

LTI Model:

Output:

13 | P a g e
Task#2: Call the file of SIMULINK design made in Task (1) into command
window system parameter and convert the parameters into Transfer Function
Representation.
Simulink Model & Code:

Task#3: Derive a transfer function for the system given below:

LTI Model:

14 | P a g e
Output:

Code:

________________________

15 | P a g e

You might also like