Scribd
Upload
176 views2 pages

Installing Usb Driver

This technical note explains how to install the USB driver for the EZware-5000 software. The driver is required to download or upload projects to an HMI5000 series PLC using a USB cable. It involves connecting the HMI5000 to the PC, allowing Windows to install a driver, and selecting the driver located in the EZware-5000 installation folder. Correctly installing the driver enables communication between the PC and PLC via USB.

Uploaded by

kdb6978
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
176 views2 pages

Installing Usb Driver

This technical note explains how to install the USB driver for the EZware-5000 software. The driver is required to download or upload projects to an HMI5000 series PLC using a USB cable. It involves connecting the HMI5000 to the PC, allowing Windows to install a driver, and selecting the driver located in the EZware-5000 installation folder. Correctly installing the driver enables communication between the PC and PLC via USB.

Uploaded by

kdb6978
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

T E C H N I C A L N O T E

Maple Model(s) PLC or Controller


HMI5000 Series N/A

Title: Installing USB Drivers for EZware-5000 Software


Summary
This document explains how to install the USB driver. This driver is necessary for downloading or
uploading projects from a PC using a USB cable.

Solution
In order for EasyBuilder to connect to an HMI5000 via USB, the Maple Systems USB driver must be
installed.

1. Make sure that EZware-5000 has been properly installed.

2. Power up an HMI5043N, HMI5056N, HMI5070NH, HMI5070TH, HMI5100NH, or an HMI5100TH.


Then connect it to the PC via the USB cable.

3. Windows will recognize a new device. A popup message similar to the following should appear:

4. After a few seconds, Windows will display the New Hardware Found dialog box. Select No, Not This
Time, and click the Next button.

. Maple Systems Inc., 808 134th Street SW, Suite 120, Everett, WA 98204-7333 – www.maplesystems.com
0907-5052 Page 1 of 2 Rev. 01, 4/27/2010
5. Select Install from a list or specific location (Advanced), and click the Next button.

6. Select the \usbdriver folder under the main software installation folder.

The default folders are:

EZware-5000 c:\MapleSystems\EZ5000\usbdriver

EZware-5000 Utilities c:\MapleSystems\EZ5000Util\usbdriver

Note If a different installation folder was selected during setup, the USBdriver folder will be under
that folder.

In rare cases, multiple drivers may be offered. Choose the one in the folder indicated above.

Note The folder for the full EZware-5000 is shown below in step 7.

7. Click the Next button.

Phone: 425/745-3229 • Fax: 425/745-3429 • Email: support@maplesystems.com • web:www.maplesystems.com


0907-5052 Page 2 of 2 Rev. 01, 4/27/2010

You might also like