Scribd
Upload
34 views4 pages

Module 2: Sketch Based Features: ENT 334 Component Design

The document provides instructions for modeling 11 different mechanical parts using sketch-based features in a CAD software. For each part depicted in a figure, the task is described as modeling the part using a specific feature function such as pad, pocket, rib, or slot. The goal is to teach students how to construct mechanical components using sketch-based modeling techniques.

Uploaded by

YiXuanYeo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
34 views4 pages

Module 2: Sketch Based Features: ENT 334 Component Design

The document provides instructions for modeling 11 different mechanical parts using sketch-based features in a CAD software. For each part depicted in a figure, the task is described as modeling the part using a specific feature function such as pad, pocket, rib, or slot. The goal is to teach students how to construct mechanical components using sketch-based modeling techniques.

Uploaded by

YiXuanYeo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

ENT 334 Component Design

MODULE 2: SKETCH BASED FEATURES

Figure 1.0: Rib

Task
Model the rib part as shown in Figure 1.0 by using the pad function with LIM 1 and LIM 2 directions.

Figure 2.0: Plate with shaft

Task
Model the plate with shaft as shown in Figure 2.0 by using the pad function with LIM 1 and LIM 2
directions.

Figure 3.0: Dual plate with shaft

Task
Model the dual plate with shaft as shown in Figure 3.0 by using the pad function with LIM 1 and LIM
2 directions.
ENT 334 Component Design

Figure 4.0: Bracket

Task
Model the bracket as shown in Figure 4.0 by using the pad function with LIM 1 and LIM 2 directions.

Figure 5.0: Rib with plate

Task
Model the rib with plate as shown in Figure 5.0 by using the surface pad function with LIM 1 and LIM
2 directions.

Figure 6.0: Hub

Task
Model the hub as shown in Figure 6.0 by using the surface pocket function.
ENT 334 Component Design

Figure 7.0: Hub

Task
Model the hub as shown in Figure 7.0 by using the up to next pocket function.

Figure 8.0: Hub

Task
Model the hub as shown in Figure 8.0 by using shaft function.

Figure 9.0: Hub


ENT 334 Component Design
Task
Model the hub as shown in Figure 9.0 by using groove function.

Figure 10.0: Metal channel

Task
Model the metal channel as shown in Figure 10.0 by using rib function.

Figure 11.0: Mould

Task
Model the mould as shown in Figure 11.0 by using slot function.

You might also like