Scribd
Upload
62 views1 page

Questionnaire On Pile Foundation & Load Testing

The document is a questionnaire focused on pile foundation and load testing, covering specifications such as minimum diameter and concrete grades according to MoRTH V revision. It also addresses cementitious materials not recommended for certain soil conditions and outlines initial load testing requirements. The questionnaire includes multiple-choice questions to assess knowledge on these topics.

Uploaded by

Dwijendra Chanumolu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
62 views1 page

Questionnaire On Pile Foundation & Load Testing

The document is a questionnaire focused on pile foundation and load testing, covering specifications such as minimum diameter and concrete grades according to MoRTH V revision. It also addresses cementitious materials not recommended for certain soil conditions and outlines initial load testing requirements. The questionnaire includes multiple-choice questions to assess knowledge on these topics.

Uploaded by

Dwijendra Chanumolu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Questionnaire on Pile foundation & load testing

1. The Minimum Dia of the concrete Pile in River & marine Conditions as per MoRTH V revision is:

a)1.0 Mtr b)0.6Mtr c)1.2 Mtr d)0.75Mtr.

2. The Minimum Grade of concrete for the Cast In situ & Pre-cast concrete Piles as per MoRTH V
revision are:

a)M30 & M35 b)M35 &M40 c)M35 & M35 d)M40 & M35

3. When Both Sulphates & Chlorides are present in Soil & Ground, which of the following is not
recommended as cementitious material for Pile Construction as per IRC: 112 is:

a) Fly ash b) Sulphate Resistant Cement c) Silica Fumes d) GGBS

4. The Initial Load test on pile deriving its bearing capacity through End bearing & Friction bearing
should be:

a) Maintain Load Test b) Cyclic Load Test c) Dynamic Load test d) None.

5. The Minimum load to be tested for initial load test on a Test pile should be the ___ time sits
design load.

a) 1.5 b)2.0 c) 2.5 d) 3.0.

You might also like