0.60MTS. 0.60MTS.

GENERAL PLUMBING NOTES PLUMBING LEGENDS : 0.40

0.10 0.40 0.10 12MMØ HOR.
& VERT.BAR

1. ALL SANITARY WORKS INCLUDE HEREIN SHALL BE EXECUTED ACCORDING

TO THE PROVISIONS OF THE NATIONAL PLUMBING CODE OF THE PHILIPPINES, T F/ FAUCET D.D.F DRAINAGE DOWN FLANGED 6" CHB
HE NATIONAL BUILDING CODE OF THE PHILIPPINES, AND ITS IMPLEMENTING RULES AND
REGULATIONS. LAV LAVATORY W.D.F WASTE DOWN FLANGED
20MMØ RSB
SHO SHOWER R.D ROOF DRAIN 0.40
2. COORDINATE THE DRAWING WITH OTHER RELATED DRAWINGS AND SPECIFICATIONS. 0.60MTS. 0.70 MTS
THE ARCHITECT AND/OR THE ENGINEER SHALL BE NOTIFIED IMMEDIATELY OF ANY FD FLOOR DRAIN W.U.F. WATER UP FLANGED
DISCREPANCY FOUND THEREIN. HIS/HER DECISION SHALL BE FINAL. W.D.F. WATER DOWN FLANGED
KS KITCHEN SINK
3. ALL PIPES SHALL BE INSTALLED AS INDICATED. ANY RELOCATION REQUIRED FOR WATER LINE
PROPER EXECUTION OF OTHER TRADES SHALL BE WITH PRIOR APPROVAL OF THE CB CATCH BASIN
ARCHITECT AND/OR THE ENGINEER. SOIL PIPE
CO CLEAN OUT PLAN SECTION
4. PROPOSED SANITARY UTILITIES SHALL CONFORM TO THE ACTUAL LOCATION, DEPTH SEPTIC TANK
FURNISH CLAMP FOR
AND INVERT ELEVATION OF EXISTING PIPES AND STRUCTURES AS VERIFIED BY THE GV GATE VALVE
CONTRACTOR. ADJUSTABLE
ATTACHING WATER-
PROOFING MEMBRANE
OR METAL FLASHING 1 CATCH BASIN DETAIL
STRAINER HEAD TO SEEPAGE PANS
U.F UP FLANGED FINISHED FLOOR
P 2 SCALE MTS.
CONCRETE
5. THE CONTRACTOR SHALL BE RESPONSIBLE FOR ALL REQUIRED FLOOR AND WALL
OPENINGS.
D.F DOWN FLANGED
WP WASTE PIPE WATER PROOF
MEMBRANE
SEEPAGE PAN WEEP HOLES
6. ALL SLOPES FOR HORIZONTAL DRAINAGE SHALL MAINTAIN 1% AS MINIMUM, UNLESS D.S DOWNSPOUT
OTHERWISE
NOTED.
PVTR PIPE VENT. THRU ROOF
P-TRAP WASTE LINE

7. SIZE OF WATER SUPPLY PIPES TO FIXTURES SHALL BE IN ACCORDANCE WITH THE

MANUFACTURER'S INSTRUCTIONS. 1.50 1.00 1.00 2 FLOOR DRAIN DETAILS
P 2 NOT TO SCALE
8. ALL FIXTURES SHALL BE VENTED, UNLESS OTHERWISE NOTED.

9. THE WORK THROUGHOUT SHALL BE EXECUTED IN THE BEST AND MOST THOROUGH VENT

MANNER KNOWN TO THE TRADE AND TO THE SATISFACTION OF THE ARCHITECT AND/OR
THE ENGINEER. VENT

T
UL

C
C.O.
10. THE CONTRACTOR SHALL VERIFY ALL EXISTING UTILITIES AT SITE AND COORDINATE 1.50 VA CB
C.O. C.O.
TIC SHO

THE WORKS WITH THE SEWER EFFLUENT DISPOSAL AND WATERLINE SERVICE
C.O.
S EP
F
CONNECTING POINT.

B
CO

11. REFER TO TECHNICAL SPECIFICATION FOR DETAILED MATERIAL AND EQUIPMENT CB WC SINK CB
LAV
SPECIFICATIONS. FD

A
F
G E K. SINK

RA
O
CB ST REA
Y A N
DR REA HE CB
PLAN UN A TC
LA KI A
ARE
SPECIFICATIONS NG
2 NI
1. COLD WATER LINE - GALVANIZED IRON (G.I) SCHEDULE 40 OM N EA

1
CO MANHOLE CO CO
O DI
AR
MANHOLE MANHOLE CB
CB DR
BE IN
G
2. SOIL AND WASTE PIPES - 2" TO 4" DIAMETER, POLYVINYL CHLORIDE (PVC) SERIES 1000 AIR SPACE AIR SPACE AIR SPACE LIV
1
6" AND ABOVE, POLYVINYL CHLORIDE (PVC) CLASS 35 WITH ALL SOLVENT JOINT M CB

2
O
FITTINGS ONLY. R O H
CB
BED RC EM
PO ST
3. VENT PIPES - POLYVINYL CHLORIDE (PVC) SERIES 1000 WITH ALL SOLVENT JOINT SY
1.50 TO I NE TO G
E
FITTINGS ONLY. P RL P NA
TA ATE TA RAI

3
W D
4. DRAINAGE PIPES - 6" TO 8" DIAMETER, POLYVINYL CHLORIDE (PVC) CLASS 35 WITH ALL CB
SOLVENT JOINT FITTINGS ONLY.

4
5. DOWNSPOUTS - POLYVINYL CHLORIDE (PVC) SERIES 1000 WITH ALL SOLVENT JOINT 8
SAND

FITTINGS ONLY. 1
EM
0.10 ST
GRAVEL

SY

5
TO GE
6. PIPE SEALANT - POLYVINYL CHLORIDE (PVC) PIPES : PVC SOLVENT CEMENT GRAVEL BED
P NA
TA RAI
GALVANIZED IRON PIPES : PTFE (POLYTETRAFLUOROETHYLENE) THREAD SEAL TAPE. D

7. VALVES - "KITZ", "CRANE", OR APPROVED EQUIVALENT.

UP TO 50 mm : BRONZE ASTM B62, 1034 kPa CLASS, THREADED END.
65 mm UP : ALL IRON, BRONZE FITTED, 1034 kPa, FLANGED END.
SECTION 4 ISOMETRIC VIEW
P 2 SCALE 1 : 100 MTS.

3 SEPTIC TANK DETAILS

P 2 SCALE 1 : 30 MTS.

MASTER PLUMBER: APPROVED BY: REVISION: PROJECT TITLE: PROJECT OWNER: R.A. 9266
SHEET CONTENTS:
SECTION 20

P-2
DRAWINGS AND SPECIFICATIONS DULY SIGNED, STAMPED
ONE STOREY MS. JULIET B. DURAN
OR SEALED AS INSTRUMENTS OF SERVICE ARE THE PROPERTIES
UNLAWFUL FOR ANY PERSON, WITHOUT THE WRITTEN CONSENT
OF THE ARCHITECT OR AUTHOR OF SAID DOCUMENTS FOR THE
RESIDENTIAL BUILDING USE IN THE REPETITION OF AND FOR OTHER PROJECTS OR
BUILDING, WEATHER EXECUTED PARTLY OR IN WHOLE.
P.R.C. REG NO.: P.T.R. NO.:
MUNICIPAL ENGINEER C.P.C. HOME ADDRESS
PRESIDENTIAL DEGREE NO. 49 OR PROTECTION OF AS SHOWN
1111
NARRA SITIO CANNIOGAN, INTELLECTUAL PROPERTY DATED NOVEMBER 14, 1972.
VALIDITY: DATE ISSUED: LOCATION: DATE ISSUED: SAN MANUEL, PANGASINAN WORKS OF ART, ARCHITECTURE, MODELS AND DESIGNS
ARE CREATIVE AND CONSIDERED AS PART OF THE
DATE APPROVED INTELLECTUAL PROPERTY OF THE AUTHOR DULY PROTECTED
UNDER P.D. 49.
TIN NO.: PLACE ISSUED: PLACE ISSUED: JANUARY 16, 2021
NARRA SITIO CANNIOGAN, SAN MANUEL, PANGASINAN