Code No: 57037 Set No.
JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD
IV B.Tech. I Sem., I Mid-Term Examinations, DEC-2020
DEPARTMENT OF ECE
COMPUTER NETWORKS
Objective Exam
Name: ______________________________ Hall Ticket No.
A
Answer All Questions. All Questions Carry Equal Marks. Time: 20 Min. Marks: 10.
I. Choose the correct alternative:
1. How many bits are there in Ethernet address [ ]
a. 64 bits b. 32 bits c. 16 bits d. None
2. The Network Layer concerns with [ ]
a. Bits b. Frames c. Packets d. None
3. The 4 bit IP address consists of [ ]
a. Network address b. Port address c. both a&b d. None
4. Multi Access Control is Divided in to [ ]
a. 2 b. 3 c. 4 d. 1
5. Error detection at the Data Link Level achieved by [ ]
a. Cyclic redundancy code b. Bit Stuffing c. Hamming Code d. Equalization
6. Start and Stop bits are used in a serial communication for [ ]
a. Error Detection b. Error Correction c. Synchronization d. None
7. A high speed communication equipment typically would not be needed [ ]
a. Email b. Message c.LAN Communication d. None
8. The method communication in which transmission takes place in both directions, but
only in one direction at a time is called________ [ ]
a. Simplex b.Half duplex c. Full duplex d. None
9. Protocols are [ ]
a. Agreement on how communication components
b. Physical communication channels are used for transferring data
c. Both a&b
d. None
10. How layers are there in TCP/IP model [ ]
a. 4Layers b. 7 Layers c. 6 Layers d. 8 Layers
Cont…..2
Code No: 57037 :2: Set No. 1
II Fill in the Blanks:
11. ______________________ Layer of OSI model also called end to end layer.
12. _____________________ provides a connection oriented reliable service for sending
Messages.
13. Bridge works in ___________________ layer of OSI model.
14. The technique in which the data link layer automatically stuff bit ‘0’ after five
consecutive 1’s____________________.
15. In _________________ scheme transmission proceeds immediately if the carrier is Idle.
16. In pure ALOHA, channel utilization, expressed throughput S, in terms of offered load G
is given by ____________
17. Ethernet uses ________________ coding.
18. When the frame returns to the sending station, that station removes the frame from the
ring by a process called ________________.
19. ______________ ensures that error free data is transferred between the adjacent nodes in
the network.
20. The last address of IP Address represents _______________.