0% found this document useful (0 votes)
48 views1 page

About Coatings

The document discusses several single element fertilizer additives and coatings sold by Omex, including chelated micronutrients and molybdenum. It describes the products' uses for preventing and correcting nutrient deficiencies in crops. Imphos and TPA are liquid additives meant to coat phosphorus fertilizers to prevent the phosphorus from becoming tied up in the soil and reduce deficiencies. The document recommends application rates for these products.

Uploaded by

yanri cahyo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
48 views1 page

About Coatings

The document discusses several single element fertilizer additives and coatings sold by Omex, including chelated micronutrients and molybdenum. It describes the products' uses for preventing and correcting nutrient deficiencies in crops. Imphos and TPA are liquid additives meant to coat phosphorus fertilizers to prevent the phosphorus from becoming tied up in the soil and reduce deficiencies. The document recommends application rates for these products.

Uploaded by

yanri cahyo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Single Elements

ADDITIVES
OMEX SINGLE ELEMENTS ARE FULLY CHELATED SOLUTIONS OF:
• Copper EDTA 7.5% • Iron EDTA 5%
• Zinc EDTA 9% • Ferrogreen
• Manganese EDTA 5% • Omex Moly

OMEX chelated micronutrients (Zn, Cu, Mn, Fe) are recommended for the prevention and
correction of deficiencies in crops (1-4L/ac). OMEX Moly is a water soluble solution with a
guaranteed analysis of 1.5% or 3% Molybdenum. It is recommended for the prevention and
correction of Molybdenum deficiency in crops, to encourage nodulation in pulses, especially
in acidic soils (low pH). The preferred use is as a soil application to prevent deficiency. When
soil application is not possible, OMEX Single Elements may be applied in-crop alone or
with pesticides or other fertilizers, directly to the foliage to correct deficiency. OMEX Single
Elements may be applied via ground sprayers (high-volume), aircraft or fertigation systems.

Fertilizer Coatings
& Additives:
(50% CARBOXYLATES)

Imphos is a liquid additive specifically formulated to impregnate dry Phosphorus


(MAP, DAP, …) in order to prevent its tie-up with Ca2+ (calcareous soils), Fe2+ and Al3+
(acidic soils). It has been formulated in a highly concentrated form to be applied at low
volume on dry fertilizer, enhancing drying time and reducing chances for caking. Once
applied to the soil, the impregnated Phosphorus is protected in a readily available form
for a period of 100-150 days, depending on the moisture and temperature conditions.
ImPhos is recommended at a rate of 0.5-1.0 L per acre with the starter fertilizer
and 3.0 L/ metric ton of dry fertilizer.

(38% AI)

TPA is a liquid additive intended to be used with the liquid starter fertilizer
(Ortho P, 10-34-0) or to impregnate dry Phosphorus (MAP, DAP, …). TPA enhances
nutrient availability and maximizes Phosphorus use efficiency. In addition, the negatively
charged molecule reduces Phosphorus tie-up with Ca2+ (calcareous soils) or Fe2+/Al3+
(acidic soils). TPA provides 10% of Potassium that triggers the release of additional
Potassium from the clay layers and is biodegradable, preventing the accumulation
of any residuals over time.
TPA is recommended at a rate of 0.5-1.0 L per acre with the starter fertilizer
and 3.0 L/ metric ton of dry fertilizer.

866-860-9660 / omexcanada.com
290 Agri Park Road, Oak Bluff, MB R4G 0A5

You might also like