Product Overview
The ICT FP-001 Programmer is designed for easy updating A6/A7 Serial
Bill Acceptor Flash ROM.
COM2 PH
L1 PC Programmer
COM1
Programmer
L2 PC Target
L3 Programmer Target
L4 Programmer Status
RESET / START
FP-001
Programmer
L1 L2 L3 Program Normal
1
Cable Connection
1. Connecting RS-232 cable to the each side of PC & Programmer.
(PC ------- COM1 Port) (Programmer --------- COM2 Port)
2. Connecting a RJ-45 cable from PH port on the Programmer to
Bill Acceptor's RJ-45 port.
Operation Manual
Function 1: (PC --------- Programmer)
1. Switch to L1 position, the L1 on the top LED will stay green
(PC Programmer)
2. The L4 LED will be flashing. If not, Please push the Reset/Start key
to reset Programmer. Also make sure the programming Dipswitch
on Normal Position.
3. Launch application software Flash16.exe located on you CD. Make sure
Choose the CPU type is MB90F549, Speed as 16MHZ, COM1 port (or
COM2 depends on your computer configurations). Press search to load
the Currency Flash File that you want to use. Click Auto.
4. Remember During the downloading, L4 LED will become orange and
flashing. When it's finish. The L4 LED will stay as orange. Press Reset
/ Start key again to reset the Programmer. LED will flash as normal
green. The new Flash File will stores on the FP-001 Programmer Now.
2
Function 2: (PC---------Target)
1. Switch to L2 position, L2 LED on the top will stay green (PC Target)
2. The L4 LED will be flashing. If not, Please push the Reset/Start key
to reset Programmer. Also make sure programming Dipswitch
on Normal position.
3. Using the Step as Function 1 shows above to launch application
software Flash16.exe located on you CD to download new Flash File
directly to Bill Acceptor. That means at this time. The FP-001
Programmer just like a path to communicate between you PC and Bill
Acceptor. No Flash file will store on FP-001 Programmer.
Function 3: (Programmer---------Target)
1. Switch to L3 position, the L3 on the top LED will stay green
(Programmer Target)
2. The L4 LED will be flashing, If not please push the Reset/Start key
to restart Programmer. Also make sure Programming Dipswitch on
Normal position.
3. At this time it's ready for programming the Bill Acceptor by using
FP-001 Programmer.
4. Presses the Start Switch one time, Wait a few seconds. The L4 will
turn red and Flashing. It means it's doing programming, erasing and
verifying.
LED Display As Follow
(1). RED (Starts)
(2). OFF (Erasing)
(3). RED Flashing (Verifying)
(4). ORANGE (Finish)
5. When it finished. L4 LED will stay orange. Now, Press Start switch
again to Let the Bill Acceptor auto adjust sensor. Remember in the
front of the Bill Acceptor LED will stay green. Insert a testing write
card; The BA will eject the Card after finished adjusting.
6. Press one more time Start key, The Bill Acceptor will automatically
power cycle It. The Bill Acceptor just finished Updating new flash.
7. Now you can take this pre-programmed FP-001 Programmer to another
Bill Acceptor. Just simply connecting the RJ-45 cable from PH port on
the Programmer to Bill Acceptor's RJ-45 port. Just repeat Function 3
(Programme r------- Target) to program every Bill Acceptor on this time.
3
