Specification data

KOYO Elevator Type TKJ

Load capacity(Kg) 1150
Speed(m/s) 1.0
Traction ratio 2:1
Opening mode C.O
Door net size(mm) 900*2100-YS
Car net size(mm) 1500*1600*2300
Overhead height(mm) 6930
Pit depth(mm) 1600
Travelling height(m) 10.93
L/F/D 4/4/4
Machine Type Gearless
Motor Power(Kw) 7.6
Rated Current(A) 17.1
Main Power Supply 380V AC±7% 50 HZ 3P
Light Power Supply 220 V 50 HZ
Counterferce(kg)
R1 11600
R2 9000
R3 5880
R4 6380
R5 3500

notice
1.The shaft shall be made of concrete or bricks without any that is
hollow. The load of its surrounding wall shall be at least 24Mpa.
The prefabricated parts shall be performed as per what drawings
indicate.
2.The shaft wall shall be vertical to horizon based on plumb line,
with max. tolerance 0-25mm.
3.The shaft is made specially for elevator. Placement of any
irrelevant objects (cable, water pipes, etc.) is prohibited. Any
unauthorized entrance is prohibited.
4.Keep machine room dry and ventilated with temperature 5°C-40°C.
The load of ground base shall be at least 7000Pa, and ?90% when
circumstance relative humidity is at 25°C.
5.It shall be with enough illumination at the passage to shaft and at
the stairs. The stairs base shall be strengthened enough when main
drive needs to be carried through stairs, and with stair width at
least 1200mm and inclination ˇÜ45°.
6.Power supply shall be by final consumer. Fuse switch device is
located on the wall beside the door of machine room.
7.Earthing device shall be by final consumer with resistance <4¦¸.
8.The illumination of machine room shall be at least 200Lux.
9.As per drawings requirement, pit and buffer plate shall be of
waterproof. Final consumer shall have it filled with cement when
buffer installation.
10.A ladder shall be prepared by final consumer for maintenance
personnel's easy entrance to pit.
11.The min. distance between two floors shall be at 2.60m, and
emergency exit shall be equipped between the two floors in case
the distance is at 11m.
12.It is better that shaft shall be at the space that is of difficult
reach. In case there is space under car and counterweight that is
of easy reach, pit base shall be designed as per 5000Pa of load,
and counterweight buffer shall be installed up to solid support on
the ground, or catch block shall be equipped for counterweight.
13.One power socket shall be set in pit.
14.The depth of wall and landing door is less than 250mm in this
drawing. Please contact our sales dept. for any special requirement
you may have.

Drawing
Client name Design
No.
Project name Auditing Page

Seal of Signature
customer Date
KOYO ELEVATOR CO,.LTD.
NOTE: Do Not Scale This Drawing.Unless Otherwise Stated.All Dimensions In mm.
KOYO

Drawing
Client name Design
No.
Project name Auditing Page

Seal of Signature
customer Date
KOYO ELEVATOR CO,.LTD.
NOTE: Do Not Scale This Drawing.Unless Otherwise Stated.All Dimensions In mm.
KOYO

Drawing
Client name Design
No.
Project name Auditing Page

Seal of Signature
customer Date
KOYO ELEVATOR CO,.LTD.
NOTE: Do Not Scale This Drawing.Unless Otherwise Stated.All Dimensions In mm.
KOYO

Drawing
Client name Design
No.
Project name Auditing Page

Seal of Signature
customer Date
KOYO ELEVATOR CO,.LTD.
NOTE: Do Not Scale This Drawing.Unless Otherwise Stated.All Dimensions In mm.