Scribd
Upload
1K views5 pages

Nissan Conexiones 2plu Pinout

The document provides instructions for connecting a serial suite to an ECU plug and reading or writing to an ECU. It specifies to connect the red wire to the 2 pin red power supply, black wire to the 1 pin black ground. It advises to check the ECU type and shows images of where to connect the flat cable and location of the write protection wire on the back of the ECU.

Uploaded by

pineda87
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views5 pages

Nissan Conexiones 2plu Pinout

The document provides instructions for connecting a serial suite to an ECU plug and reading or writing to an ECU. It specifies to connect the red wire to the 2 pin red power supply, black wire to the 1 pin black ground. It advises to check the ECU type and shows images of where to connect the flat cable and location of the write protection wire on the back of the ECU.

Uploaded by

pineda87
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Connect as below:

Serial Suite: ECU Plug:

Red to 2 Pins Red (Power Supply +12 Volt)


Black to 1 Pins Black (Ground)

Piasiniengineering info@piasinienginnering.it – http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298
ATTENTION:

Before do anything check the type of MCU


if
SH7055
or
SH7058

Piasiniengineering info@piasinienginnering.it – http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298
Where to connect the flat cable:

Backside:

Piasiniengineering info@piasinienginnering.it – http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298
READ the ECU:

Backside:

Piasiniengineering info@piasinienginnering.it – http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298
WRITE the ECU:

For write the ECU put 1 wire(Bridge) like in the picture.

Piasiniengineering info@piasinienginnering.it – http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298

You might also like