100% found this document useful (2 votes)
1K views7 pages

Hica-Datacom H12-811 V8.02.: Correct Correct Correct

The document contains a quiz on networking topics. It asks multiple choice questions about protocols like PPP, VLAN configuration, STP, ACLs, SNMP, IPv6, and wireless LAN security. The correct answers are identified for each question.

Uploaded by

Asma Elmangoush
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
100% found this document useful (2 votes)
1K views7 pages

Hica-Datacom H12-811 V8.02.: Correct Correct Correct

The document contains a quiz on networking topics. It asks multiple choice questions about protocols like PPP, VLAN configuration, STP, ACLs, SNMP, IPv6, and wireless LAN security. The correct answers are identified for each question.

Uploaded by

Asma Elmangoush
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 7

HICA-DATAcom H12-811 V8.02.

1. Which of the following protocols consist of the PPP protocol? (Multiple Choice)
 LCP correct
 PPPoE
 NCP correct
 Authentication protocol correct

6. The network administrator created VLAN 10 on the Layer 3 switch and configured an IP
address under the virtual interface of the VLAN. When the command "display ip interface brief"
is used to check the port status, it is found that the VLANIF 10 interface is in the down state.
What should be done to restore the VLANIF 10 interface to normal?

 Add an interface that must be Up and must be of type Trunk into VLAN 10
 Assign any physical interface to VLAN 10 wrong
 Assign a physical interface that must be Up to VLAN 10
 Use the command "undo shutdown" under VLANIF 10 interface correct

7. When the Trunk port send the data frame, how to deal with?
 When the VLAN ID is the same as the PVID of the port and is a VLAN ID allowed by
the port, remove the Tag and send the message correct
 When the VLAN ID is different from the PVID of the port, the data frame is dropped
 When the VLAN ID is different from the PVID of the port, replace it with PVID
forwarding
 When the VLAN ID is different from the PVID of the port, strip off the TAG and
forward

12. By default, the root path cost of the root bridge in the STP protocol must be 0.
 True correct
 False
By default, it takes at least 30s for the port status in the STP protocol to change from Disabled to
Forwarding.

 True correct
 False

- As shown in the figure below, the wrong statement is:


acl number 2000]
rule 5 deny source 200.0.12.0 0.0.0.7
rule 10permit source200.0.12.0 0.0.0.15 #
interface GigabitEthernetO/0/1 traffic-filter outbound acl2000

 The host whose source IP address is 200.0.12.4 cannot access the Internet
 The host whose source IP address is 200.0.12.2 cannot access the Internet
 The host whose source IP address is 200.0.12.8 cannot access the Internet correct
 The host whose source IP address is 200.0.12.6 cannot access the Internet

15. vty configuration as shown in the figure, the user authority level is set to level 3.
[Huawei]user-interface vty o 14
[Huawei-ul-vtyo-14]acl 200o inbound
[Huavei-ui-vtyo-14]user privilege level 3
[Huavei-ui-vtyo-14]authentication-node password Please configure the login password (maxim
length 16):huawei
 False
 True correct
21. Which WLAN security policies support the link authentication method of Open mode?
(Multiple Choice)
 WPA2-802.IX correct
 WPA2-PSK
 WEP correct
 WPA correct
SNMP is a standards based network management protocol widely used on TCP/IP networks. It
provides a method for managing NEs through a central computer that runs network management
software, that is, a network management station (NMS). An SNMP NMS and SNMP agent
communicate with each other through the TCP protocol.
 True.
 False Correct

22. Which of the following SNMP packets are sent to the NMS by the Agent on the managed
device?
 Set-Request
 Get-Request
 Get-Next-Request
 Response correct
23. Which of the following statements about RA and RS in IPv6 are correct? (Multiple Choice)
 RS is used to reply address prefix information correct?????
 RA is used to request address prefix information
 RS is used to request address prefix information correct
 RA is used to reply address prefix information correct

You might also like