Scribd
Upload
45 views4 pages

Exp6 Lab

The document provides instructions for dismantling, inspecting, adjusting, and assembling a clutch assembly. It details removing components like the pressure plate, springs, and drive plate. It also covers inspecting parts for wear or cracks and reassembling the clutch by placing springs and plates back together before securing with bolts.

Uploaded by

Ramesh Kavitha Sanjit 18BME0677
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
45 views4 pages

Exp6 Lab

The document provides instructions for dismantling, inspecting, adjusting, and assembling a clutch assembly. It details removing components like the pressure plate, springs, and drive plate. It also covers inspecting parts for wear or cracks and reassembling the clutch by placing springs and plates back together before securing with bolts.

Uploaded by

Ramesh Kavitha Sanjit 18BME0677
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Assembling and disassembling of clutch

AIM: To dismantle, inspect, adjust and assemble the clutch assembly.

TOOLS & EQUIPMENT: A clutch assembly, Spanner set, screw driver, clutch fixture, etc., PROCEDURE:
DISMANTLING OF CLUTCH:

1. To mount clutch assembly on clutch fixture.

2. Mark driving and pressure plate, so that they may be replaced in the same relative position on
reassembly

3. Remove the set screw holding the with spring plate to the withdrawal plate and remove the
withdrawal plate.

4. Compress the clutch assembly using fixture.

5. Loosen the bolts on the adjuster pads and remove the trust pads.

6. Slowly relieve the pressure on the springs by unscrewing the clutch fixture.

7. Separate the pressure plate, springs and the drive plate 8. Remove the bolts holding the lever
brackets on the driving plate, and dismantle the withdrawal lever.

INSPECTION: 1. Examine the contact faces of pressure plate and face plate for cracks and wear.

2. Inspect the clutch linear of wear. If necessary reline the clutch using rivet and hammer.

ASSEMBLING OF THE CLUTCH:

1. Place the pressure plate under the clutch fixture.

2. Place the spring on the pressure plate.

3. Assemble the lever brackets along with the lever pivot pin, bush etc., on the driving plate Apply
grease on the pivot pin and bush while fitting.

4. Lay the driving plate complete with springs cups and lever bracket assemblies on the top springs,
making sure the identification marks line up.

5. Compress the assembly slowly, making sure the springs are seated properly then fit the trust pads
with stepped portions upwards and tighter the bolts.

6. Release the pressure on the clutch and remove the clutch assembly.

7. Locate the clutch withdrawal plate on the levers and tighten the bolts securing the spring plate.

RESULT: Thus the given single plate dry type clutch is dismantled, overhauled, reassembled and
adjusted

You might also like