the Ancient Egyptians used electricty to power their lights and the pyramids acted as giant

powerplants generating consistent energy for the lights. Arguments for this theory: 1. the pyramids
were coated with limestone (which acted as an insulator to keep energy inside) 2. granite lined the
shafts, causing ionization of the air (aka electric charge) 3. Due to aquifers (water... channels
underground) below the pyramids, electricty was transmitted by way of additional channels to the
pyramids from the moving water AND the last one I will share, 4. the capstone(!) made of Gold, an
excellent conductor of electricity (fact!).

The pyramid curve exactly match earth's radius. 2x the perimeter of the bottom of the granite coffer X 10**8 is the
sun's mean radius.{ 270.45378502 PI* 10**8 = 427,316 miles}Theres a universal relationship betw the diameter of a
circle and its circumference. The ht of the Pyramid's apex is 5,812.98 in, and ea side is 9,131 in fr corner to corner. If
the circumference of Pyramid is divided by 2x its ht (the diameter of a circle is 2x the radius), the result is 3.14159,
w/c just happens to be pi.

The alignments at Teotihuacan, Giza and the Constellation Orion are very similar. This is suggested that the
construction of both pyramids were with the knowledge and assistance of those with astrological and/or celestial
knowledge.

Pyramid a cosmic antenna, tuning into the earth's magnetic frequency putting out a low sound frequency,at the same
time receives cosmic (gamma-ray) energy via "zero pt.ENERGY FIELD, produced by the form of the structure
thereby forming a vortex where the God's particle can flow
http://rickzepeda.hubpages.com/hub/Egypt-Pyramid-Secret-Information
Ancient Pyramid Connection across the planet There are thousands of pyramids across the planet. Some of the most
impressive in Mexico, Bosnia, Egypt, Peru, Indonesia, Italy, Sudan and China- to name a few. The pyramids have a
huge meaning and are connected with the stars, consciousness, our ancient past and so much more that should be
shared with us. They are perfectly precise and in alignment with each other and with the Ley Lines of the Earth.

1. There are many more ancient sites across the planet which seem to form a pattern. It has been determined
that there is a 25,000 mile long circle which goes directly through much of the most significant sites across
the globe. SOUTH AMERICA: Paracas, Peru Nazca, Peru Ollantaytambo Macchu Pichu Sacsayhuaman
Paratoari AFRICA: Mali (Dogon territory) Tassili N’Ajjer in Algeria Siwa, Egypt Giza, Egypt Petra Ur
Persepolis, Iran Mohenjo Daro, Pakistan Khajuraho Pyay Sukothai, Thailand Angkor Wat Preah Vihear,
Cambodia Easter Island
Despite seemingly insurmountable obstacles, the resourceful Egyptians devised a grand plan.Their solution to an
adequate water supply was to construct masonry structures in the form of four sided pyramids on ground high
enough to escape the flood waters. Into the outer structure were incorporated all the astro scientific knowledge they
deemed fit, and in the inner structure were incorporated chambers, conduits, valves and plugs constituting a
gargantuan hydraulic ram water pump to both purify water and pump it above the flood plain to public fountains in
the nearby cities.

exerpt from: 'ALL ABOUT HYDRAULIC RAM PUMPS How and Where They Work ' by D.R.Wilson
The hydraulic ram pump is a reliable, old-time water pump that works just as well today as ever. Often called a water
ram or ram, one of these simple devices can pump water from a flowing source of water (spring, creek, river, etc.) to
any point above the source, and this without any power requirement except the force of water moving downhill,
contained inside a ‘drive pipe‘. A 30-degree angle is ideal. Moving water contains a small amount of kinetic energy
(inertia): this is the energy of water falling downhill under the force of gravity, called Fall. The ram pump is constructed
to utilize this inertia to pump some of that water to a point highter than the source of water. It runs all the time,
requires no fuel, needs only minor periodic maintenence.
Water flows downhill--it is moving. Contained within a pipe ('drive pipe' ) it is incompressable, almost as if it were
solid. As far as physics is concerned, it is. Think of a hammer. It weighs so much...but simply laying the head on a
nail does no good. Swing the hammer--it is moving. It strikes the nail with far more force than its mere weight. Inertia,
object moving, stopped suddenly. Force. Or think of the old battering ram against the castle gates. Weight of log,
movement by warriors, stopped suddenly by the gate. Force. Pillage and looting.
The drive pipe full of water, moving downhill, stopped suddenly by the 'clack' valve closing, Force.. against the 'check
valve', opens it against the pressure in the 'high pressure' side of the ram pump. A small amount of that water (about
10%-15%) gets through and eventually ends up at the end-use area.

Winds

A pulsar (from pulse and -ar as in quasar)[1] is a highly magnetized, rotating neutron star or white dwarf, that emits a
beam of electromagnetic radiation. This radiation can be observed only when the beam of emission is pointing toward
Earth (much the way a lighthouse can be seen only when the light is pointed in the direction of an observer), and is
responsible for the pulsed appearance of emission. Neutron stars are very dense, and have short, regular rotational
periods. This produces a very precise interval between pulses that range from milliseconds to seconds for an
individual pulsar. Pulsars are believed to be one of the candidates of the observed ultra-high-energy cosmic rays (see
also Centrifugal mechanism of acceleration).
Resonant earthed system:

■ Adding inductive reactance from the system neutral point to ground is an easy method of limiting the
available ground fault from something near the maximum 3 phase short circuit capacity (thousands of
amperes) to a relatively low value (200 to 800 amperes).
■ To limit the reactive part of the earth fault current in a power system a neutral point reactor can be
connected between the transformer neutral and the station earthing system.
■ A system in which at least one of the neutrals is connected to earth through an
1. Inductive reactance.
2. Petersen coil / Arc Suppression Coil / Earth Fault Neutralizer.
■ The current generated by the reactance during an earth fault approximately compensates the capacitive
component of the single phase earth fault current, is called a resonant earthed system.
■ The system is hardly ever exactly tuned, i.e. the reactive current does not exactly equal the capacitive
earth fault current of the system.
■ A system in which the inductive current is slightly larger than the capacitive earth fault current is over
compensated. A system in which the induced earth fault current is slightly smaller than the capacitive

earth fault current is under compensated

■ However, experience indicated that this inductive reactance to ground resonates with the system shunt
capacitance to ground under arcing ground fault conditions and creates very high transient over voltages
on the system.
■ To control the transient over voltages, the design must permit at least 60% of the 3 phase short circuit
current to flow underground fault conditions.
■ Example. A 6000 amp grounding reactor for a system having 10,000 amps 3 phase short circuit capacity
available. Due to the high magnitude of ground fault current required to control transient over voltages,
inductance grounding is rarely used within industry.

The author of the article below titled, Ancient Pyramids Were High Frequency Power Stations, theorizes that
reason for the huge disconnects is because there is a conscious effort by global elites to hoard sacred
technologies for their own personal enrichment and financial gain.

To demonstrate what I am talking about, the video below is relatively short at a running length of only about
10 minutes, and it will will provide you with a very high level overview of the information that is known about
the ancient pyramids. It turns out that ancient Egypt was actually oozing with electrical power, and it was the
ancient pyramids that served as high frequency power stations. During ancient times, the pyramids had a
layer of limestone the coated the entire outside, and it was said to have been cut so precisely, the not even a
razor could get between blocks. The limestone on the outside did not contain magnesium, which had the
effect of keeping all the power generated inside the pyramid so it could be harnessed.

The stones that makeup the inner portion of the pyramids are made of a different kind of stone than the
outside. The ones inside contained a form of crystal to carry the electricity, as well as a form of metal. The
chambers inside the pyramids are all lined with granite which acts as a conductor, and permits the ionization
of the air within the shafts. As you’ll learn in the video, the electricity comes generated by the pyramids
comes from water that travels through aquifers beneath the pyramids that are lined with crystal. The heavy
flow of water against the crystal produces an electric current which is referred to in science as physio
electricity.

Since different parts of the pyramids were built with perfect precision to act as either conductors or an
insulators of electricity, the ancients were then able to direct that electricity accordingly to form a “wireless
electrical grid” similar to the one built by Nikola Tesla millennia later. The pyramids actually produced so
much power, that one of the ancient wonders of the world, the Lighthouse at Alexandria was an actual
lighthouse that was powered using electricity and had giant light bulb.

Pulsar clock

From Wikipedia, the free encyclopedia

Gdańsk, pulsar clock display.

A pulsar clock is a clock which depends on counting radio pulses emitted by pulsars.

Pulsar clock in Gdańsk[edit]

The first pulsar clock in the world was installed in St Catherine's Church, Gdańsk, Poland, in 2011.[1] It was the first
clock to count the time using a signal source outside the Earth. The pulsar clock consists of a radiotelescope with 16
antennas, which receive signals from six designated pulsars. Digital processing of the pulsar signals is done by an
FPGA device.[2]

Pulsar clock in Brussels[edit]

On October 5, 2011, a display showing the exact time of the pulsar clock was installed in the European Parliament in
Brussels, Belgium.[3]

References[edit]

● Jump up^ "World's most accurate clock to be built in Gdańsk". Polska Agencja Prasowa. 2010.
Retrieved 2012-03-20.[dead link]
● Jump up^ "Gdański Zegar Pulsarowy". Muzeum Zegarow Wiezowych. 2011. Archived from the
original on December 13, 2011. Retrieved 2012-03-20.
● Jump up^ "Gdański Zegar Pulsarowy w Parlamencie Europejskim". Gdanski Park Naukowo
Technologiczny. 2011. Retrieved 2012-03-20.