MasterKure® 102
A polymer, water-based, concrete curing compound
DESCRIPTION OF PRODUCT COVERAGE
MasterKure 102 is a solvent-free, polymer, water- The recommended rate of application is 0.2ltr/m2.
based emulsion, suitable for spray application to This corresponds to that at which MasterKure 102
freshly poured concrete. has been tested, and at which it attains the claimed
degree of curing efficiency. In favorable conditions,
The resultant film retains sufficient moisture in the such as shaded interior surfaces, adequate curing
concrete to ensure full hydration of the cement; can be achieved with extended coverage rates.
essential for optimum strength development.
Membrane-cured concrete is typically harder and SUBSEQUENT SURFACE FINISHES
exhibits a dust-free surface with a reduced It is important to ensure the complete removal of
incidence of drying shrinkage cracks. the MasterKure 102 prior to the application of any
surface finish or additional treatment.
PRIMARY USES
As a more effective and economical alternative to MasterCast bonding slurries must be utilised to
Hessian, water and polythene curing regimes. bond subsequent finishes. Please refer to BASF’s
Suitable for use on all concrete surfaces. Technical Services Department for approved mix
designs.
ADVANTAGES If renders of greater thickness than 1cm are to be
Eliminates the need for water applied, bond tests should be carried out to
Single application determine the proposed bonding method and
Reduces drying shrinkage surface preparation that is required.
High curing efficiency For floor areas, the curing compound must be
Reduced labour costs removed prior to applying subsequent finishes.
Water-based
SPECIFICATION CLAUSE MASTERKURE 102
PACKAGING
Where indicated, concrete shall be cured by
MasterKure 102 is available in 210ltr drums.
application of MasterKure 102, polymer-based
emulsion manufactured by BASF Egypt or similar
TYPICAL PROPERTIES
approved; to the following specification:
Appearance: White liquid
Specific gravity: Approx. 1.00 SPECIFICATION TYPE:
Flashpoint: Not applicable ASTM C309: Type 1 Class A
Finished film Clear opaque film
appearance:
MasterKure 102 is to be applied strictly in
Drying time 2.30 hours 20 minutes at
ASTM C309:at a 25ºC accordance with the manufacturer’s instructions.
dosage of 0.2kg/m²
STORAGE
STANDARDS Shelf life is up to 1 year when stored under cover,
MasterKure 102 meets the requirements of ASTM out of direct sunlight and protected from extremes
C309 Type 1 Class A of temperature.
MasterKure® 102
HEALTH AND SAFETY
As with all chemical products, care should be
taken, during use and storage, to avoid contact with
eyes, mouth, skin and foodstuffs. Treat splashes to
eyes and skin immediately. If accidentally ingested,
seek medical attention. Re-seal containers after
use. Use in well-ventilated areas and avoid
inhalation.
NOTE
Field service, where provided, does not constitute
supervisory responsibility. For additional
information, contact your local BASF
representative.
BASF reserves the right to have the true cause of
any difficulty determined by accepted test methods.
QUALITY STATEMENT
All products manufactured by BASF Egypt, or
imported from BASF affiliate companies world-
wide, are manufactured to procedures certified to
conform to the quality, environment, health & safety
management systems described in the ISO
9001:2008, ISO 14001:2004 & OHSAS 18001:2007
standards.
* Properties listed are based on laboratory controlled tests.
® = Registered trademark of the BASF-Group in many countries
BASF_CC-EG/Kure_102_09_10/v1/06_14
