SOLARCON SCO
MPPT Charge Controller
● Advanced microprocessor control
● Maximum Power Point Tracking (MPPT)
● Buck regulator wide input range
● 3-step charging to provide quick and safe charging
for battery
● Design for using with lead acid and Lithium-ion
batteries
● PV and battery reverse polarity protection
● Over charge and over discharge protection
● Lightning surge protection
● PV ground fault protection (option)
● Automatic cooling fan (outside enclosure)
● Comprehensive LED indication and LCD display
● Power and event data logger
● IP31 protection enclosure
● 2 years warranty (option for 3 and 5 years)
● ISO 9001 and ISO 14001 certified factory
Fluorescent light Water pump
PV array
Television Fan
Charge controller
SOLARCON SCO-series Inverter
APOLLO MTP-410 series Radio
DC DC AC
Computer Refrigerator
AC Loads
Battery
The SOLARCON SCO-series charge controller is the most sophisticate solar charger with PV Maximum Power Point
Tracking (MPPT) algorithm. The charge controller equipped with advanced microprocessor control to get the maximum
power from PV to charge battery with LCD display and front panel for easy and accurate setting more over the digital meter
with 180 days power and event logger are inclusive.
AC Solar Power System
SOLARCON SCO-series MPPT Charge Controller
SPECIFICATIONS
Model SCO-4860 SCO-4880 SCO-48120
INPUT (Configuration of PV in series within these voltage range)
Vmp of PV* 64 - 116 Vdc
Voc of PV* ≤ 145 Vdc
Maximum PV power** 3.3 kWp 4.4 kWp 6.6 kWp
OUTPUT (at 25°C)
Nominal battery voltage 48 Vdc
Boost charging voltage 52.0 - 60.0 Vdc (default = 60.0 Vdc)
Float charging voltage 48.0 - 56.0 Vdc (default = 55.2 Vdc)
Voltage regulation ± 0.5 V (steady load)
Low voltage alarm 40.0 - 48.0 Vdc (default = 47.2 Vdc)
Low battery voltage 39.6 - 47.6 Vdc (default = 43.2 Vdc)
disconnected
Reconnect voltage 46.0 - 54.0 Vdc (default = 50.0 Vdc)
Maximum charging current 60 A 80 A 120 A
BATTERY
Type Deep cycle lead acid (LA) and Lithium-ion (Li-ion)
EFFICIENCY
Charger peak efficiency > 98%
PROTECTION
Protection PV transient voltage surge, PV and battery reverse polarity,
High battery voltage, Low battery voltage,
Over temperature, Over charge and discharge,
PV ground fault (option)
INDICATOR
LED Battery level, PV voltage level, Operation status, Alarm
LCD Digital meter, 180 days power and event logger
COMMUNICATION INTERFACE
Selectable by setting RS-232 (default) or RS-485
Dry contact signal Charger fail and low battery voltage disconnected
SYSTEM
Control Automatic cooling fan, Maximum Power Point Tracking (MPPT)
Temp. compensation range -5 to 7 mV / cell / celsius (option)
OPERATING CONDITION
Temperature 0 - 45˚C
Relative humidity 0 - 95% (non-condensing)
DIMENSION (W x H x D) (approximate in cm.)
Wall mount case 23 x 31 x 16 cm 32.3 x 42 x 16 cm
WEIGHT (approximate in kg.)
Wall mount case 7.2 kg 7.6 kg 12.2 kg
*The Vmp and Voc used for configuration must be considered with temperature coefficient effected by environment at each install location.
**For operation of charge controller at ambient temperature ≤ 25˚C. The peak PV power must be derated 15% when charge controller operates at ambient temperature over than 25˚C.
Continuous product development is our commitment. In that manner, the above specifications may be changed without prior notice.
Authorized Distributor
Authorized Dealer
LEO ELECTRONICS CO.,LTD.
27, 29 Soi Bangna-Trad Rd 34, Bangna, Bangna, Bangkok 10260 THAILAND
Tel. 0-2746-9500, 0-2746-8708 Fax. 0-2746-8712 e-mail : RNE@leonics.com
■ www.leonics.com ■ P.LEN.BRO.CCL.220 Rev.5.00/2018
