Scribd
Upload
2K views3 pages

Bosch Me7.4.9 Psa

This document provides instructions for connecting to a Bosch ME7.4.9 engine control unit used in PSA and IKCO vehicles. It states that the motherboard must be detached from both sides of the ECU and lay-by pins are located in the lower part. A direct connection is made using cable F32GN037C after ensuring the Trasdata power LED is on. The grey and blue wires of this cable are then connected to boot and configuration pins 1 on the ECU connector.

Uploaded by

Mecanica Del Automóvil
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views3 pages

Bosch Me7.4.9 Psa

This document provides instructions for connecting to a Bosch ME7.4.9 engine control unit used in PSA and IKCO vehicles. It states that the motherboard must be detached from both sides of the ECU and lay-by pins are located in the lower part. A direct connection is made using cable F32GN037C after ensuring the Trasdata power LED is on. The grey and blue wires of this cable are then connected to boot and configuration pins 1 on the ECU connector.

Uploaded by

Mecanica Del Automóvil
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

BOSCH ME7.4.

9 PSA/IKCO

plugin 47 Bosch ME7.4.9 - ST10F275 / ST10F276 PSA


plugin 824 Bosch ME7.4.9NG - ST10F275 / ST10F276 IKCO

The motherboard must be detached on both ECU sides, the lay-by pins are placed in the lower
part of the ECU.
BOSCH ME7.4.9 PSA/IKCO

DIRECT CONNECTION
In order to connect to the ECU use the CABLE F32GN037C.
Make sure that the POWER led (red) on Trasdata is ON.

ECU CONNECTOR

BOOT&CNF1 CONNECTION

Connect the GREY&BLUE wires of the cable F32GN037C as described here below :
BOSCH ME7.4.9 PSA/IKCO

You might also like