Scribd
Upload
124 views2 pages

Motor CVT Inspection Guide

This document is a checklist for inspecting parts of a motorcycle CVT transmission. It lists specific parts to inspect, such as the weight roller, movable drive face boss, and clutch outer. Measurement specifications are provided for each part, including acceptable standard ranges and service limits. The results section shows measurements taken of the parts inspected and whether they passed inspection based on falling within standard or service limit ranges.

Uploaded by

BudiahmaRoyani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
124 views2 pages

Motor CVT Inspection Guide

This document is a checklist for inspecting parts of a motorcycle CVT transmission. It lists specific parts to inspect, such as the weight roller, movable drive face boss, and clutch outer. Measurement specifications are provided for each part, including acceptable standard ranges and service limits. The results section shows measurements taken of the parts inspected and whether they passed inspection based on falling within standard or service limit ranges.

Uploaded by

BudiahmaRoyani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

TEKNIK SEPEDA MOTOR SMK AL-MUJAHID

NAMA Hari/tanggal ujian


Start: Finish:
XII TSM

CVT
SMK AL MUJAHID

PEMERIKSAAN
WEIGHT ROLLER
Periksa masing-masing roller terhadap keausan tidak normal.
Ukur D.L. weight roller

BATAS SERVIS: 17,5 mm

MOVABLE DRIVE FACE BOSS


Periksa drive face boss terhadap keausan atau kerusakan.
Ukur D.L. drive face boss.

BATAS SERVIS: 21,98 mm

MOVABLE DRIVE FACE MOVABLE DRIVE FACE

Periksa movable drive face terhadap goresan, gerusan atau


kerusakan. Ukur D.D. drive face bushing.

BATAS SERVIS: 22,11 mm

PEMERIKSAAN
CLUTCH OUTER
Periksa clutch outer terhadap keausan atau kerusakan.
Ukur D.D. clutch outer.

BATAS SERVIS: 125,5 mm

DRIVEN FACE SPRING


Ukur panjang bebas driven face spring.

BATAS SERVIS: 108,0 mm

DRIVEN FACE
Periksa driven face terhadap goresan, gerusan atau
kerusakan.
Ukur D.L. driven face boss.

BATAS SERVIS: 33,94 mm

Hasil
BAGIAN Kesimpulan STANDARD BATAS SERVIS
Pengukuran
Lebar drive 19,0 18,0
belt
Movable drive D.D. bushing 22,035 – 22,085 22,11
face D.L. boss 22,010 – 22,025 21,98
D.L. weight roller 17,92 – 18,08 17,5

Clutch Tebal lining - 2,0


D.D. clutch outer 125,0 – 125,2 125,5
Driven pulley Panjang bebas 111,4 108,0
face spring
D.L. driven face 33,9 – 34 33,94
D.D. movable 34,0 – 34,2 34,06
driven face

You might also like