Scribd
Upload
97 views2 pages

Backlash Inspection

This document provides instructions for inspecting and adjusting the motor backslash on a cutting unit. It describes how to use a control instrument to measure the backslash between the motor gear and driving gear at 8 points spaced 135 degrees apart. The mean value of the measurements should not exceed 0.1 mm, with a 0.04 mm tolerance. Diagrams show how the roller fixing screws, adjusting block, and blade holder determine the 8 check points for measurement.

Uploaded by

armando olivares
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
97 views2 pages

Backlash Inspection

This document provides instructions for inspecting and adjusting the motor backslash on a cutting unit. It describes how to use a control instrument to measure the backslash between the motor gear and driving gear at 8 points spaced 135 degrees apart. The mean value of the measurements should not exceed 0.1 mm, with a 0.04 mm tolerance. Diagrams show how the roller fixing screws, adjusting block, and blade holder determine the 8 check points for measurement.

Uploaded by

armando olivares
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

CHAPTER 5 - SPECIAL MAINTENANCE 63

M2. CUTTING UNIT

Inspections

M2.I1 M2.I3

M2.I2

M2.I1 Motor backslash inspection

NOTE: The motor backslash must be checked at operating temperature.


Perform inspections or adjustments at the end of the work shift or after
leaving the machine in operation for about 20 minutes.

1. Apply the supplied control instrument on the protruding part of the motor
shaft, as shown in the figure, and tighten it (A).

12345
12345
12345
A
1 - Control instrument.
2 - Support surface.
12345
of the comparator pin
3 - Comparator.
123
123
123
1

123
123
123
2
123
123
123
3

MACCHINE PER C ARTONE O NDULATO . MASTER 21.30 N° CMST02700ING


64 PART III - MAINTENANCE

2. Place the comparator steadily (A) and so that the read is performed on
the support surface of the supplied instrument.
3. reset the comparator and measure the backslash between motor gear
and driving gear, moving the motor shaft by hand.

NOTE: grip the adjusting sleeve firmly and move it without making your
hand slide on the grip.

The read should be repeated on 8 points at an angular distance of 135° and the
mean value of the measures taken should not exceed 0.1 mm. A tolerance of
0.04 mm around such value is allowed.

1 3

4 8
135

7 5
2

The arrangement of the roller fixing screws (A), of the adjusting block (B) and of
the blade holder is such as to determine the 8 check points during rotation. Fix
a point on the side (C) and move the roller on the check points, using a 17 bush
wrench.

123
123
123
C

123
123
123
A 123
123
123
B

MACCHINE PER CARTONE ONDULATO. MASTER 21.30 N° CMST02700ING

You might also like