C-Band IBUC R

Frequency Range RF (MHz) IF (MHz) SSB Phase Noise External Reference IBUC R

Sense Inverting Non-Inverting 10 Hz -115 dBC/Hz -54 dBc/Hz

Band 1 std C 5850 to 6425 950 to 1525 950 to 1525 100 Hz -140 dBc/Hz -79 dBc/Hz
Band 2 Palapa 6425 to 6725 975 to 1275 1125 to 1425 1 KHz -150 dBc/Hz -89 dBc/Hz
Band 3 INSAT 6725 to 7025 1150 to 1450 965 to 1265 10 KHz -155 dBc/Hz -94 dBc/Hz
Band 4 EXT C 5850 to 6650 950 to 1750 950 to 1750 100 KHz N/A -100 dBc/Hz
Band 5 Full C 5850 to 6725 975 to 1850 950 to 1825 1 MHz N/A -110 dBc/Hz

Input External Reference (Multiplexed on TX IFL)

VSWR/Impedance 1.5:1 max/ 50 Ohm Frequency 10 MHz

Input Connector Type N Female (50 Ohm) Level -12 to +5 dBm

Input Connector Options Type F (75 Ohm), TNC (50 Ohm) Internal Reference- Optional

Input Power Detector Range -55 to -20 dBm (80W - 200W) Local Oscillator Frequency
-50 to -15 dBm (400W)
Sense Inverting Non-Inverting
Gain
Band 1 7375 MHz 4900 MHz
Small Signal Gain (L-band to RF) with Attenuator Set to 0 dB
Band 2 7700 MHz 5300 MHz
100W 81 dB min
Band 3 8175 MHz 5760 MHz
125W 82 dB min
Band 4 7600 MHz 4900 MHz
150W 83 dB min
Band 5 7700 MHz 4900 MHz
175W 83 dB min
200W 84 dB min
IBUC Power Supply
400W 82 dB min
Voltage DC 42 V min, 60 V max
Attenuator Range 30 dB Variable in 0.1 dB Steps
AC 100 to 240 VAC 100W, 125W
Gain Flatness
200 to 240 VAC 150W to 400W
Full Band 4 dB p-p max
36 MHz 1.5 dB p-p max
Power Consumption DC AC
1 MHz 0.25 dB p-p max
Gain Variation Over Temperature Bands 1/2/3 Bands 4/5
100W 700 W 800 VA
Open Loop 3 dB p-p max 4 dB p-p max
125W 800 W 900 VA
With AGC 1 dB p-p max 1 dB p-p max
150W 1056 W 1200 VA
RF Output
175W 1100 W 1250 VA
Interface CPR-137G
200W 1150 W 1300 VA
VSWR 1.3:1 max
400W N/A 2600 VA
Rated Output Power P1dB
Monitor & Control
100W +50 dBm min
Ethernet (HTTP, Telnet, SNMPv2c) via RJ45 Connector
125W +51 dBm min
RS232/485, Handheld Terminal via MS-Type Connector,
150W +51.8 dBm min
FSK multiplexed on TX IFL.
175W +52.4 dBm min
Environmental
200W +53 dBm min
Operating Temperature -40°C to +55°C
400W +56 dBm min
Relative Humidity 100% Condensing
Note: Output Power in Bands 4 & 5 is reduced by 0.5 dB.
Altitude 10,000 ft (3,000 m) ASL
IMD3 (2 Carriers, 3 dB TOBO) -26 dBc max (80W-200W)
-25 dBc max (400W)
Level Stability with ALC ± 0.5 dB Mechanical DC Powered AC Powered
Output Power Detector Range Rated Power to -20 dB 100W-200W 16.2 x 10 x 7.4 in. 16.2 x 10 x 7.6 in.
411 x 254 x 188 mm. 411 x 254 x 193 mm.
Power Reading Accuracy ± 1.0 dB max
32 lbs 33 lbs
Spurious
14.5 kgs 14.9 kgs
In Band -70 dBc
Out Band Complies with EN 301 443 & MIL-STD 188-164B. 400W N/A 29 x 15 x 10.1 in
737 x 381 x 257 mm.
Harmonics -50 dBc max.
83 lbs
Output Noise Power Density TX <- 74 dBm/Hz (Dimensions not including isolators for 100W to 200W models)
37.6 kgs
RX <- 145 dBm/Hz Specifications subject to change without notice. Updated 9/21/2020

Questions? Contact Us 315 Digital Drive

1+(408) 782-5911 Morgan Hill, CA 95037
Sales@TerrasatInc.com www.TerrasatInc.com