4-Port Antenna

1695-2690 | 1695-2690 MHz

65° 1394 mm

6177100
6177100N 6177100G 6177100NG
2-Band, 4-Port, 65°, XPOL, Panel Antenna, Variable Tilt, 1394 mm

 Twin band antenna, dual polarisation, 4 connectors

 Independent tilt on each band 0-12° / 0-12°
 MET and RET versions, 3GPP/AISG2.0
 Single RET module to control all tilt angles, fully inserted inside the antenna (field replaceable)

Frequency Range (MHz) 1695-2690 1695-2690

Array  Y1  Y2
PRODUCT OVERVIEW

Connector 1-2 3-4

Polarization XPOL XPOL

Azimuth Beamwidth (avg) 65° 65°

Electrical Downtilt 0-12° 0-12°

Dimensions 1394 x 265 x 114 mm

ORDERING OPTIONS Select from the different options listed below

SELECT ELECTRICAL DOWNTILT SELECT SELECT CONNECTOR ANTENNA MODEL

CONTROL & AISG PROTOCOL ACTUATOR TYPE NUMBER

4.3-10 Female 6177100N

Manual Electrical Tilt (MET) ---
7/16-DIN Female 6177100

4.3-10 Female 6177100NG

Remote Electrical Tilt (RET) Multi-Device Control Unit
AISG v2.0 / 3GPP (MDCU)
7/16-DIN Female 6177100G

Quoted performance parameters are provided to offer typical, peak or range values only and may vary as a result of normal testing, manufacturing and operational conditions. Extreme
operational conditions and/or stress on structural supports is beyond our control. Such conditions may result in damage to this product. Improvements to products may be made without notice.

CON N EC T I N G P E O P L E + T E C H N O L O G Y
REV020718I 1 of 5
www.amphenol-antennas.com
 4-Port Antenna
1695-2690 | 1695-2690 MHz
65° 1394 mm

6177100
6177100N 6177100G 6177100NG
2-Band, 4-Port, 65°, XPOL, Panel Antenna, Variable Tilt, 1394 mm

ELECTRICAL SPECIFICATIONS Ultra Wide Band  Y1

Frequency Range MHz 1695-2690
MHz 1695-1880 1850-1990 1920-2180 2300-2500 2490-2690
Polarization --- ±45°
Gain Over all Tilts dBi 16.6 ± 0.4 16.6 ± 0.5 16.5 ± 0.5 16.6 ± 0.3 17.0 ± 0.5
Azimuth Beamwidth degrees 70.7 ± 3.8 70.0 ± 4.3 72.3 ± 7.2 68.5 ± 3.1 62.7 ± 3.9
Elevation Beamwidth degrees 7.1 ± 0.4 6.5 ± 0.3 6.1 ± 0.5 5.4 ± 0.2 5.0 ± 0.3
Electrical Downtilt degrees 0°-12°
Impedance Ohms 50
VSWR --- < 1.5
Passive Intermodulation
dBm < -110
3rd Order for 2 x 20W Carriers
Front-to-Back Ratio, Total Power, ±30° dB > 32.0 > 30.7 > 28.0 > 27.8 > 25.7
Upper Sidelobe Suppression, Peak to 20° dB > 18.5 > 18.5 > 18.3 > 17.8 > 15.1
Main Direction (0°) dB > 21.8 > 19.2 > 17.9 > 22.2 > 19.0
Cross Polar
Ratio Sector Edges (±60°) dB > 10.3 > 11.4 > 12.1 > 7.7 > 6.6
Maximum Effective Power Per Port Watts 160 W
Inter/Intra Band Isolation dB > 30
Standard values based on NGMN-P-BASTA version 9.6 recommendation.

ELECTRICAL SPECIFICATIONS Ultra Wide Band  Y2

Frequency Range MHz 1695-2690
MHz 1695-1880 1850-1990 1920-2180 2300-2500 2490-2690
Polarization --- ±45°
Gain Over all Tilts dBi 16.7 ± 0.4 16.7 ± 0.5 16.7 ± 0.4 17.1 ± 0.5 17.1 ± 0.6
Azimuth Beamwidth degrees 71.5 ± 3.0 70.0 ± 3.1 72.9 ± 4.4 67.4 ± 4.0 62.7 ± 3.5
Elevation Beamwidth degrees 7.1 ± 0.3 6.5 ± 0.4 6.0 ± 0.5 5.4 ± 0.2 5.0 ± 0.3
Electrical Downtilt degrees 0°-12°
Impedance Ohms 50
VSWR --- < 1.5
Passive Intermodulation
dBm < -110
3rd Order for 2 x 20W Carriers
Front-to-Back Ratio, Total Power, ±30° dB > 31.7 > 30.1 > 27.4 > 28.7 > 26.4
Upper Sidelobe Suppression, Peak to 20° dB > 17.6 > 17.2 > 16.1 > 16.8 > 15.7
Main Direction (0°) dB > 21.5 > 19.9 > 19.2 > 21.8 > 19.6
Cross Polar
Ratio Sector Edges (±60°) dB > 9.0 > 9.5 > 10.9 > 8.2 > 7.1
Maximum Effective Power Per Port Watts 160 W
Inter/Intra Band Isolation dB > 30
Standard values based on NGMN-P-BASTA version 9.6 recommendation.
Quoted performance parameters are provided to offer typical, peak or range values only and may vary as a result of normal testing, manufacturing and operational conditions. Extreme
operational conditions and/or stress on structural supports is beyond our control. Such conditions may result in damage to this product. Improvements to products may be made without notice.

CON N EC T I N G P E O P L E + T E C H N O L O G Y
REV020718I 2 of 5
www.amphenol-antennas.com
 4-Port Antenna
1695-2690 | 1695-2690 MHz
65° 1394 mm

6177100
6177100N 6177100G 6177100NG
2-Band, 4-Port, 65°, XPOL, Panel Antenna, Variable Tilt, 1394 mm

ELECTRICAL DOWNTILT CONTROL

For multiband antennas, electrical downtilt for each band can be controlled separately. Tilt indicator(s) are covered by removable transparent cap(s).

Manual Electrical Tilt (MET) A colored knob at the end of the tilt indicator allows change of the tilt without need of a tool. The knob color is identical
Control to the corresponding connector color. To access the knob, remove the cap by turning it counter-clockwise. It is
re-installed by opposite rotation. Do not remove the transparent cap(s) from the antenna.

The remote control of the electrical tilt is managed by a Multi-Device Control Unit (MDCU) inserted in the bottom of the
Remote Electrical Tilt (RET)
antenna. See details below and refer to the ordering options to see which actuators are available with this particular
Control
antenna. A single actuator individually controls the tilt of each band (no need for daisy chain cables between the bands).
This module does not add any additional length to the antenna. For RET control, the transparent caps must be in place
and locked. The tilt angle indicators always remain visible and the antenna still has manual tilt control (manual override).
Do not remove the transparent cap(s) from the antenna.

RET ACTUATOR
Amphenol's RET-READY antennas are delivered with the RET Actuator already installed and pre-commissioned with all antenna parameters. Every
RET device is factory configured and calibrated so the antenna is ready to be used once delivered to the site which means that there is no need for
further installation of RET devices or for programming their configuration or for running a calibration process.

RET-READY Multi-Device Control Unit (MDCU). The MCDU is an electronic module that allows the remote control of the electrical downtilt (RET)
ACTUATORS in Amphenol antennas with factory embedded motors. The MDCU is factory installed. Refer to the ORDERING OPTIONS for
availability with this model

Number of RET-READY Actuators One per antenna

Input Voltage +10 to +30 V

Power Consumption Idle State 0.5 W

Operating 4 W typical / 10 W maximum

Protocol 3GPP/AISG 2.0

Tilt Change Duration Less than 15 seconds, typical (may vary dependent on antenna type and outdoor temperature)

Precision ±0.5°

Tilt Change Capability 50,000 minimum

RET Interface 1 pair of AISG Male and Female (type IEC60130-9)

Field Replaceable Unit Yes

Quoted performance parameters are provided to offer typical, peak or range values only and may vary as a result of normal testing, manufacturing and operational conditions. Extreme
operational conditions and/or stress on structural supports is beyond our control. Such conditions may result in damage to this product. Improvements to products may be made without notice.

CON N EC T I N G P E O P L E + T E C H N O L O G Y
REV020718I 3 of 5
www.amphenol-antennas.com
 4-Port Antenna
1695-2690 | 1695-2690 MHz
65° 1394 mm

6177100
6177100N 6177100G 6177100NG
2-Band, 4-Port, 65°, XPOL, Panel Antenna, Variable Tilt, 1394 mm

Top
ARRAY LAYOUT

ARRAY FREQUENCY CONNECTOR CONNECTOR TYPE

Y1 Y2
7/16-DIN Female Long Neck or 4.3-10
 Y1 1695-2690 1-2
Female

7/16-DIN Female Long Neck or 4.3-10 Left Right

 Y2 1695-2690 3-4 Bottom
Female

Diagram shown at right depicts the view from the front of the antenna.
The illustration is not shown to scale.

MECHANICAL SPECIFICATIONS
Length mm (in) 1394 (54.9)
Width mm (in) 265 (10.4)
Depth mm (in) 114 (4.5)
Net Weight - Antenna Only kg (lbs) 13 (28.7)
Mechanical Distance Between Mounting Points mm (in) Refer to Diagram
Windload Calculation km/h (mph) 150 (93.2)
(Wind Tunnel Coefficients)
Frontal N (lbf) 651 (146.4)
Lateral N (lbf) 260.4 (58.5)
Rearside N (lbf) 705.3 (158.6)
Operational Wind Speed km/h (mph) 160 (99.4)
Survival Wind Speed km/h (mph) 200 (124)
Radome Color --- Gray RAL7035
Radome Material --- Outdoor Plastic
Lightning Protection --- Direct Ground

Shipping Dimensions (Length x Width x Depth) mm (in) 1575 x 420 x 247 (62.0 x 16.5 x 9.7)
Shipping

Shipping Weight kg (lbs) 22 (48.5)

Shipping Volume m3 (ft3) 0.163 (5.76)

Quoted performance parameters are provided to offer typical, peak or range values only and may vary as a result of normal testing, manufacturing and operational conditions. Extreme
operational conditions and/or stress on structural supports is beyond our control. Such conditions may result in damage to this product. Improvements to products may be made without notice.

CON N EC T I N G P E O P L E + T E C H N O L O G Y
REV020718I 4 of 5
www.amphenol-antennas.com
 4-Port Antenna
1695-2690 | 1695-2690 MHz
65° 1394 mm

6177100
6177100N 6177100G 6177100NG
2-Band, 4-Port, 65°, XPOL, Panel Antenna, Variable Tilt, 1394 mm

ENVIRONMENTAL SPECIFICATIONS
Environmental Standard --- ETS 300 019
Operating Temperature ° C (° F) -40° to +60° (-40° to 140°)
Product Environmental Compliance --- Product is RoHs Compliant

ACCESSORIES All accessories are ordered separately unless otherwise indicated

ITEM MODEL NUMBER WEIGHT

Brackets for pole Ø48 to Ø115 mm (Ø1.9 to Ø4.5 in) delivered as standard 0900181/00 3.4 kg (7.5 lbs)

Brackets for pole Ø70 to Ø150 mm (Ø2.8-Ø5.9 in) optional 0900182/00 3.9 kg (8.6 lbs)

Kit to add mechanical tilt (0° to 10°) to above brackets optional 0900397/00 3.0 kg (6.6 lbs)

Wall mounting brackets are available upon request

INSTALLATION

9
Please read all installation notes before installing this product.

Always attach the antenna by all mounting points.

Do not install the antenna with the connectors facing upwards. 132

Do not cut the tethered transparent caps(s) that cover the 28.5
antenna's tilt adjustment indicators.
In order to operate the RET control, the transparent caps
covering the tilt adjustment indicators must be engaged and
locked.

265
1394 3
1128

114
134
74

Quoted performance parameters are provided to offer typical, peak or range values only and may vary as a result of normal testing, manufacturing and operational conditions. Extreme
operational conditions and/or stress on structural supports is beyond our control. Such conditions may result in damage to this product. Improvements to products may be made without notice.

CON N EC T I N G P E O P L E + T E C H N O L O G Y
REV020718I 5 of 5
www.amphenol-antennas.com