Yanbu National Petrochemical Company Site Safety Procedures Manual
Yanbu Petrochemical Complex U & O Project July 2005
Fluor Arabia Limited Contract A2IT Page 1 of 2
ATTACHMENT B
NEW HIRE ORIENTATION TEST
Name: ________ Instructor:______________________
Badge No.: _______ Date:___________________________
1. When the emergency alarm sounds, you should?
(a) Shut off equipment, close valves on gas cylinders
(b) Proceed to the designated assembly point
(c) Remain at the assembly point until the all clear signal is given
(d) All of the above
2. Report injuries immediately to?
(a) Co-Worker
(b) Supervisor
(c) Safety Representative
(d) Medical facility
3. Which of the following are examples of eye protection?
(a) Safety glasses with side shields
(b) Chemical goggles
(c) Face shield
(d) All of the above
(e) A and B only
4. 100% Tie-Off is required when working.
(a) 1.8 meters (6-feet) or more from an unprotected area
(b) 3.0 meters (10-feet) or more from a protected area
(c) When I think I need it
5. Which of the following are examples of safe lifting practices?
(a) Bending at the knees, keeping back straight and lifting with arm and leg muscles
(b) Asking for help
(c) Using lifting equipment, hoist, cranes, chain falls, etc.
(d) All of the above
6. If when preparing to use an electrical tool you discover that it is defective or has an out of date inspection color code
you should?
(a) Try to make necessary repairs
(b) Go ahead and use it because the job has to get done
(c) Lay it down and use another employee’s tool
(d) Return it to the tool-room
(e) Try to make necessary repairs
H:\000_General\Share\501 - Construction\SITE SAFETY PROCEDURES\04b-Orientation-Test.doc GENERAL SITE CONDITIONS AND SAFETY PROCEDURES
Yanbu National Petrochemical Company Site Safety Procedures Manual
Yanbu Petrochemical Complex U & O Project July 2005
Fluor Arabia Limited Contract A2IT Page 2 of 2
New Hire Orientation Test cont'd.
7. Which of the following are examples of safe ladder practices?
(a) Use a ladder of sufficient length for the work to be performed
(b) Place an extension ladder so that it's base is out 1/4 the distance of the height
(c) Ladders are to be tied off
(d) All of the above
8. Which of the following describe how to transport compressed gas cylinders
(a) Proper racks and upright position
(b) Two employees carrying it
(c) Laying it on the ground and rolling it
(d) All of the above
9. Container labeling and Material Safety Data Sheets are two key elements of the Hazard Communication Program.
To obtain access to a Material Safety Data Sheet you must?
(a) Submit a request in writing
(b) Contact the project superintendent first
(c) Ask your supervisor if it is ok
(d) Simply ask
10. Match the applicable permit for the work to be performed.
(a) Cutting or burning
(b) Entering a vessel
(c) Changing out a pump
(d) Breaking the flange on a product line
(e) Working in a 1.2 meter or deeper ditch
* Opening and Blinding * Lock and Tag
* Hot Work * Confined Space
* Excavation * Cold Work
H:\000_General\Share\501 - Construction\SITE SAFETY PROCEDURES\04b-Orientation-Test.doc GENERAL SITE CONDITIONS AND SAFETY PROCEDURES
