8’ x 20’ Floating Dock

240”
48” 48” 48” 48” 48” W
K K F
2
F F F
F F
24”
DECK BOARD DIRECTION

J J J INTER-DOCK
CONNECTION
H G H H G H AT CORNER
2
H G H H G H
H H
3
G H H G
3
H H 12” F Z

2
H G G H H G G H
H H
INTER-DOCK
1 J 4 4 J 1 24” 96” CONNECTION
AT SIDES
H G H H G G H H G H
2
H H G H H G H H
H G
3
H H
3
G H 12” F Y

2
H G G H INTER-DOCK
H H
CONNECTION

F
J J J
F
24” AT CORNER

F F F
2
F
K K

237” X

HARDWARE REQUIRED: PART # QTY. LUMBER REQUIRED: LENGTH QTY.

G - Joist Corner DE99002F 20 1 - End Stringers 2" x 6" x 96" 2
H - Washer Plate DE99006F 40 2 - Center Stringers 2" x 6" x 237" 6
F - Backer Plate DE93122F 8 3 - Cross Stringer 2" x 6" x 12" 4
K - Outside Corner DE99004F 4 4 - Cross Stringer 2" x 6" x 21" 2
P - Chain Retainer DE99013F 2 5 - Deck Boards 5/4" x 6" x (At least 96") 40
J - Howell 550 Float (shown) DE99246F 8
J - Howell 400 Float (*requires additional lumber and alternate layout) DE99242F 10
Hardware Fastener Kit (8 pack Carriage Bolts, Lock Washers & Nuts) DE85100F 14
Float Fastener Kit (8 pack Lag Bolts & Flat Washers) DE85125F 8 IMPORTANT: CMP Group Ltd. assumes no responsibility or liability for the accuracy or representation of the
graphic illustrations shown in this hardware guide. These graphic illustrations are not intended to
U - Connector Pin DE96111F 2 be architectural drawings, and are not to be substituted for engineered drawings. Each is intended
as a guideline ONLY. CMP Group Ltd. does not warrant the quantities and/ or bill of materials to be accurate in all uses
W - Male Corner Hinge DE99009F 1 or 2 and applications. Individual dock structures may vary by necessity, preference or design. It may be necessary to vary
the amount of materials listed in this guide depending on dock size, material usage, necessity and/ or the severity of
X - Female Corner Hinge DE99010F 1 or 2 the conditions to which the dock structure is subjected to. All graphic illustrations are based on the use of conventional
framework of 2” x 6” lumber and decking lumber. Freeboard may be adjusted by using 2” x 8” or 2” x 10” lumber.
Y - Female T Connector DE99012F 1 or 2 Substitutions in lumber and hardware placement may affect floatation.

Z - Male T Connector DE99011F 1 or 2

300 New Huntington Rd, Woodbridge, ON, L4H 0R4 800-295-3625 www.dockedge.com