Product data sheet ATS01N206LU
Characteristics soft starter for asynchronous motor - ATS01 - 6
A - 200..240V - 0.75..1.1 KW
Product availability: Stock - Normally stocked in distribution facility
Main
Range of product Altistart 01
Product or component Soft starter
type
Product destination Asynchronous motors
Product specific applica- Simple machine
tion
Device short name ATS01
Phase 3 phases
[Us] rated supply volt- 200...240 V - 10...10 %
age
Motor power kW 0.75 kW 3 phases 200...240 V
It is the duty of any such user or integrator to perform the appropriate and complete risk analysis, evaluation and testing of the products with respect to the relevant specific application or use thereof.
1.1 kW 3 phases 200...240 V
Motor power hp 1 hp 3 phases 200...240 V
1.5 hp 3 phases 200...240 V
IcL starter rating 6A
Utilisation category AC-53B EN/IEC 60947-4-2
Current consumption 30 A at nominal load
Type of start Start with voltage ramp
The information provided in this documentation contains general descriptions and/or technical characteristics of the performance of the products contained herein.
Power dissipation in W 4 W at full load and at end of starting
This documentation is not intended as a substitute for and is not to be used for determining suitability or reliability of these products for specific user applications.
64 W in transient state
Neither Schneider Electric Industries SAS nor any of its affiliates or subsidiaries shall be responsible or liable for misuse of the information contained herein.
Complementary
Assembly style With heat sink
Function available Integrated bypass
Supply voltage limits 180...264 V
Supply frequency 50...60 Hz - 5...5 %
Network frequency 47.5...63 Hz
Output voltage <= power supply voltage
[Uc] control circuit voltage Built into the starter
Starting time 1 s 100
10 s 10
5 s 20
Adjustable from 1 to 10 s
Deceleration time symb Adjustable from 1 to 10 s
Starting torque 30...80 % of starting torque of motor connected directly on the line supply
Discrete input type Logic LI1, LI2, BOOST stop, run and boost on start-up functions <= 8 mA 27
kOhm
Discrete input voltage 24...40 V
Discrete input logic Positive LI1, LI2, BOOST < 5 V and <= 0.2 mA > 13 V >= 0.5 mA
Discrete output current 2 A DC-13
3 A AC-15
Discrete output type Open collector logic LO1 end of starting signal
Relay outputs R1A, R1C NO
Discrete output voltage 24 V 6...30 V open collector logic
Minimum switching current 10 mA 6 V DC relay outputs
Maximum switching current 2 A 250 V AC inductive cos phi = 0.5 20 ms relay outputs
2 A 30 V DC inductive cos phi = 0.5 20 ms relay outputs
Display type 1 LED green starter powered up
1 LED yellow nominal voltage reached
Tightening torque 4.42 lbf.in (0.5 N.m)
16.81...22.12 lbf.in (1.9...2.5 N.m)
Aug 9, 2019
1
Electrical connection 4 mm screw clamp terminal rigid 1 1...10 mm² AWG 8 power circuit
Screw connector rigid 1 0.5...2.5 mm² AWG 14 control circuit
4 mm screw clamp terminal rigid 2 1...6 mm² AWG 10 power circuit
Screw connector rigid 2 0.5...1 mm² AWG 17 control circuit
Screw connector flexible with cable end 1 0.5...1.5 mm² AWG 16 control circuit
4 mm screw clamp terminal flexible without cable end 1 1.5...10 mm² AWG 8
power circuit
Screw connector flexible without cable end 1 0.5...2.5 mm² AWG 14 control cir-
cuit
4 mm screw clamp terminal flexible with cable end 2 1...6 mm² AWG 10 power
circuit
4 mm screw clamp terminal flexible without cable end 2 1.5...6 mm² AWG 10
power circuit
Screw connector flexible without cable end 2 0.5...1.5 mm² AWG 16 control circuit
Marking CE
Operating position Vertical +/- 10 degree
Height 4.88 in (124 mm)
Width 1.77 in (45 mm)
Depth 5.16 in (131 mm)
Product weight 0.93 lb(US) (0.42 kg)
Compatibility code ATS01N2
Motor power range AC-3 0.55...1 kW at 200...240 V 3 phases
1.1...2 kW at 200...240 V 3 phases
Motor starter type Soft starter
Environment
Electromagnetic compatibility Damped oscillating waves level 3 IEC 61000-4-12
Electrostatic discharge level 3 IEC 61000-4-2
Immunity to electrical transients level 4 IEC 61000-4-4
Immunity to radiated radio-electrical interference level 3 IEC 61000-4-3
Voltage/Current impulse level 3 IEC 61000-4-5
Conducted and radiated emissions level B CISPR 11
Conducted and radiated emissions level B IEC 60947-4-2
EMC immunity EN 50082-2
Harmonics IEC 1000-3-2
Harmonics IEC 1000-3-4
Immunity to conducted interference caused by radio-electrical fields level 3 IEC
61000-4-6
Micro-cuts and voltage fluctuation IEC 61000-4-11
EMC immunity EN 50082-1
Standards EN/IEC 60947-4-2
Product certifications CSA
B44.1-96/ASME A17.5 for starter wired to the motor delta terminal
CCC
GOST
C-Tick
UL
IP degree of protection IP20
Pollution degree 2 EN/IEC 60947-4-2
Vibration resistance 1.5 mm peak to peak 3...13 Hz EN/IEC 60068-2-6
1 gn 13...150 Hz EN/IEC 60068-2-6
Shock resistance 15 gn 11 ms EN/IEC 60068-2-27
Relative humidity 5...95 % without condensation or dripping water EN/IEC 60068-2-3
Ambient air temperature for operation 14...104 °F (-10...40 °C) without derating
104...122 °F (40...50 °C) with current derating of 2 % per °C
Ambient air temperature for storage -13...158 °F (-25...70 °C) EN/IEC 60947-4-2
Operating altitude <= 3280.84 ft (1000 m) without derating
> 3280.84 ft (1000 m) with current derating of 2.2 % per additional 100 m
Ordering and shipping details
Category 22392 - ATSU01/ATS01 LOW HP SOFT STARTERS
Discount Schedule I11
GTIN 00785901703488
Nbr. of units in pkg. 1
Package weight(Lbs) 1.2
2
Returnability Y
Country of origin DE
Offer Sustainability
California proposition 65 WARNING: This product can expose you to chemicals including:
- - - - - - - Substance 1 Lead and lead compounds, which is known to the State of California to cause can-
cer and birth defects or other reproductive harm.
- - - - - - - Substance 2 Bisphenol A (BPA), which is known to the State of California to cause birth defects
or other reproductive harm.
- - - - - - - More information For more information go to www.p65warnings.ca.gov
Contractual warranty
Warranty period 18 months
3
Product data sheet ATS01N206LU
Dimensions Drawings
Dimensions
Mounting on Symetrical (35 mm) Rail
Screw Fixing
(1) Retractable fixings
4
Product data sheet ATS01N206LU
Connections and Schema
Example of Manual Control
A1 : Soft start/soft stop unit
(1) For type 2 coordination
Q1 : Motor circuit-breaker
F3 : 3 fast-acting fuses
5
Product data sheet ATS01N206LU
Technical Description
Function Diagram
2-wire Control with Deceleration
Us : Power supply voltage
LED Green LED
1:
LI2 : Logic input
R1 : Relay output
LO1 :Logic output
LED Yellow LED
2:
3-wire Control with Deceleration
Us : Power supply voltage
LED Green LED
1:
LI2, Logic inputs
LI1 :
R1 : Relay output
LO1 :Logic output
Um : Motor voltage
LED Yellow LED
2:
