CHRYSLER
CORPORATION
WIRING DIAGRAMS
SERVICE MANUAL
1993 FRONT WHEEL DRIVE
PASSENGER VEHICLES
To order the special service tools used and
illustrated, please refer to the instructions on
inside back cover.
NO PART OF THIS PUBLICATION MAY BE
REPRODUCED, STORED IN A RETRIEVAL
SYSTEM, OR TRANSMITTED, IN ANY FORM
OR BY ANY MEANS, ELECTRONIC, MECHANICAL,
PHOTOCOPYING, RECORDING,
OR OTHERWISE, WITHOUT THE PRIOR
WRITTEN PERMISSION OF CHRYSLER
CORPORATION.
Chrysler Corporation reserves the right to make changes in design or to make
additions to or improvements in its products without imposing any obligations
upon itself to install them on its products previously manufactured.
Litho in U.S.A. Copyright © 1992 Chrysler Corporation 30M0792
NEXT PAGE ©
FOREWORD
The information contained in this Service Manual has been prepared for the
professional automotive
technician involved in daily repair operations. Information describing the
operation and use of standard and
optional equipment is included in the Owner’s Manual provided with the vehicle.
These diagrams contain the latest information at the time of publication and
incorporate the wiring schematic
for the basic vehicle and available optional equipment.
The diagrams are grouped by body type and sales division. The body codes are
explained in the General
Information section. (Example—AP-D, P=Shadow, Sundance). To locate a system or
component refer to the black
index tabs on the next page. The tab will assist you in locating the desired area
of the manual.
An alphabetical index is provided at the beginning of each section to help you in
locating a system or
component. All diagrams are identified by SHEET NUMBER which is found in the lower
right-or left-hand corner
of the page.
A Service Manual Comment form is included at the rear of this manual. Use the form
to provide Chrysler
Corporation with your comments and suggestions.
Chrysler Corporation reserves the right to change testing procedures,
specifications, diagnosis, repair
methods, or vehicle wiring at any time without prior notice or incurring
obligation.
NOTE: The acronyms, terminology and nomenclature used to identify emissions related
components in this
manual may have changed from prior publications. These new terms are in compliance
with S.A.E.
recommended practice J1930. This terminology standard (J1930) is required to comply
with the 1993
California Air Research Board (CARB) requirements.
FOR INFORMATION NOT CONTAINED IN THIS MANUAL, REFER TO THE FRONT WHEEL
DRIVE PASSENGER VEHICLES ENGINE—CHASSIS—BODY OR ELECTRICAL—FUEL—EMISSIONS
SERVICE MANUALS.
NEXT PAGE ©
GROUP TAB LOCATOR
GENERAL INFORMATION
FUSE CHARTS AND RELAY BANKS
WIRING AND COMPONENT
IDENTIFICATION
SPLICE LOCATIONS
AA-C, D, P WIRING DIAGRAMS
AC-C, D/AY-C WIRING DIAGRAMS
AG-D, AJ-C WIRING DIAGRAMS
AP-P, D WIRING DIAGRAMS
Service Manual Comment Forms (Rear of Manual)
