Cocktail
description Papers and boards certify FSC, made with e.c.f. pulp, treated
on both sides with a pearlescent finish. Available in twelve
colours.
range size grain substance
70x100 LG 120 290
technical features substance VSA Taber stiffness 15° tensile strength
ref. standard/instrument ISO 536 ISO 534 ISO 2493 ISO 1924
unit of measure g/m2 cm3/g mN kN/m
long±10% trasv±10% long±10% trasv±10%
120 ± 3% 1,2 21 11 9,2 5,8
290 ± 5% 1,25 280 140 16 9,5
Brightness (col. White Lady) - ISO 2470 (R457) - 97% ± 2
Relative Humidity 50% ± 5 ref. TAPPI 502-98
ecological features
notes The products could show light differences in paper shade
due to natural raw materials used. The product is completely
bio-degradable and recyclable. Special runs available upon
request.
Fabriano is a trademark of Fedrigoni SpA
The Company reserves the right to modify the technological features of the product in relation to market requirements.
UNI EN ISO 9001:2008 - CQ 539 Product Data Sheet COK/2R6
UNI EN ISO 14001:2004 - CQ 7847 Update 10/2011
BSI - OHSAS 18001:2007 - CQ 15229 Rev. n° 01
Cocktail is a collection of papers and boards that are suitable applications
for many applications with a modern design. It is excellent for
packaging, corporate literature, covers, inserts and brochures.
Can be used with all the main printing systems: offset, blind em- printing
suggestions
bossing, hot-foil stamping, thermographic and screen printing.
The surface has no porosity, so that oxidative inks or better inks
for plastics or UV should be used. It is also particularly important
to check the process variables, especially the fountain solution,
which must be dosed at minimum levels to ensure that emul-
sioning is kept within modest levels. We recommend a buffered
pH of 5÷5,5 with 800÷1200 µS conductivity. Anti-setoff spray is
useful and low output stacks are necessary; the application of
online varnish, if used to avoid setoff, must be tested beforehand
in order to guarantee its effective use. Drying times depend on
the quantity of ink and process variables and may vary from 8-
10 hours to more than 24 hours. In this regard, good results are
obtained with GCR grading to reduce the mass of ink deposited
on the paper. In screen-printing, and even hot foil stamping, we
recommend inks for plastic-finished surfaces.
Good results can be expected with all the main converting converting
suggestions
process: cutting, die cutting, scoring, folding, glueing, varnishing
and lamination. The surface roughness typical of these papers
may give rise to micro defects with plastic laminating caused by
incomplete adhesion of the film to the substrate. For the correct
choice of adhesive, it is advisable to carry out specific testing
with the supplier.
